7.
8.
Slide the gear shaft to the right, then slide the
friction wheel assembly from the shaft.
SECTION11: OFF-SEASONSTORAGE
Remove the six screws from the friction wheel
assembly (three from each side). Remove the
friction wheel rubber from between the friction
wheel plate.
WARNING: Never store engine with
fuel
in
tank
indoors
or
in
poorly
ventilated areas, where fuel fumes may
reach an open flame, spark or pilot light
as on a furnace, water heater, clothes
dryer or other gas appliance.
9.
Reassemble new friction wheel rubber to the
friction wheel assembly, tightening the six
screws in rotation and with equal force.
1.
If unit is to be stored over 30 days, prepare
engine for storage as instructed in the separate
engine manual included with your unit.
10.
Slide friction wheel assembly back onto the gear
shaft. Be sure to align the pin on the shift rod
with the hole in the friction wheel assembly. See
Figure 24. Reassemble in reverse order.
2.
3.
4.
Remove all dirt from exterior of engine and
equipment.
Follow lubrication recommendations on pages
14
and 15.
Store in a clean, dry area.
NOTE: When storing any type of power equipment
in an unventilated or metal storage shed, care
should be taken to rust proof the equipment. Using a
light oil or silicone, coat the equipment, especially
any chains, springs, bearings and cables.
Hex Nut
Bell Washer
Figure 26
17
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, Yard Machines Snow Blower Manuals |
|---|---|
| Tags | MTD 615, MTD E645E, MTD E665E, MTD Snow Blower Manual, Yard Machines 615, Yard Machines E645E, Yard Machines E665E |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower, Yard Machines, 615, E645E, E665E, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)