NOTE: If you placed plastic under the gas cap, be
ENGINE
certain to remove it.
Refer to engine manual for engine lubrication
instructions.
AUGER CLUTCH ADJUSTMENT
WARNING: When following instruct-
ions in separate engine manual for
draining oil, be sure to protect frame to
avoid oil dripping onto transmission
parts.
To adjust the auger clutch, refer to Final Assembly
and Adjustments section on page 9.
CARBURETOR ADJUSTMENT
WARNING: If
made to the engine while the engine is
running (e.g. carburetor), keep clear of all
any
adjustments
are
WHEELS
Oil or spray lubricant into bearings at wheels at
least once a season. Pull klick pin, remove wheels,
moving
parts.
Be
careful
of
heated
surfaces and muffler.
clean
and
coat
axles
with
a
multipurpose
automotive grease. See Figure 20.
Minor carburetor adjustment may be required to
compensate for differences in fuel, temperature,
altitude and load.
Refer to the separate engine manual packed with
your unit for carburetor adjustment information.
Oil Bearings
or Spray Lubricant
Klick
Pin
DRIVE WHEELS
The wheels may be adjusted for two different
methods of operation. The adjustment is made by
placing the klick pins in one of two different holes on
the right side of the unit. See Figure 19.
Axle
1.
2.
One Wheel Driving—On the right side of the
unit, place klick pin in the outside axle hole only.
Do not place pin through wheel hub. This
position gives power drive to the left wheel only,
making the unit easier to maneuver.
Figure 20
CHUTE CRANK
The worm gear on the chute direction crank should
be greased with multipurpose automotive grease.
Both Wheels Driving—Rotate wheel assembly
to align hole in hub with inner hole on axle
shaft. Insert klick pin in hole. Outer axle shaft
hole should be visible. See Figure 19.
AUGER SHAFT
Remove shear bolts on auger shaft. Oil or spray
lubricant inside shaft. See Figure 21.
Klick Pin in Hub
Holeand Inner AxleHole
Shear Bolts
Outside
Hole in Axle
Bearings
Figure 19
Figure 21
SECTION 9: LUBRICATION
GEAR SHAFT
Lubricate the gear shaft with a good all-weather
multi-purpose light grease at least once a season or
after every 25 hours of operation.
IMPORTANT: Keep all grease and oil off of the
friction wheel and drive plate.
WARNING: Disconnect
the
spark
plug
wire and ground against the
engine before performing any repairs
or maintenance.
14
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, Yard Machines Snow Blower Manuals |
|---|---|
| Tags | MTD 615, MTD E645E, MTD E665E, MTD Snow Blower Manual, Yard Machines 615, Yard Machines E645E, Yard Machines E665E |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower, Yard Machines, 615, E645E, E665E, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)