Drive Belt
underneath the snow thrower. See Figure 23.
1.
2.
3.
4.
5.
Drain the gasoline from the snow thrower, or
place a piece of plastic under the gas cap.
Remove the plastic belt cover on the front of the
engine by removing the two self-tapping screws.
Tip the snow thrower up and forward, so that it
rests on the housing.
Remove six self-tapping screws from the frame
cover underneath the snow thrower.
Pull the idler pulley away from the drive belt and
remove the belt from the engine pulley. You will
find the idler pulley in front of the engine and
under the belt cover that you removed earlier.
See Figure 19.
6.
7.
Working from the underside of the frame, slip
belt between the friction wheel and the friction
wheel disc. See Figure 22. You may have to
twist the belt flat in order to slide it through the
clearance between the friction wheel and the
friction wheel disc. Remove the belt completely.
Figure 23
4. Remove klick pin securing the left wheel, and
remove the wheel from the axle.
Replace new belt. Reassemble following the
instructions in reverse order.
5. Remove the four screws securing the left drive
cover to the frame. Remove the drive cover from
the side of the frame. See Figure 24.
Idler Pulley
location
Friction Wheel
Friction Wheel Disc
Drive Cover
Drive Belt
location
Figure 24
6.
Holding the friction wheel assembly, slide the
hex shaft out of the left side of the unit. The
spacer on the right side of the hex shaft will fall
and the sprocket should remain hanging lose in
the chain.
Figure 22
CHANGING FRICTION WHEEL RUBBER
7.
8.
Lift the friction wheel assembly out between the
axle shaft and the drive shaft assemblies.
Check the rubber on the friction wheel after 25 hours
of operation, and periodically thereafter. Replace the
rubber if any signs of wear or cracking are found.
Remove the six screws from both sides of the
friction wheel assembly. Remove friction wheel
rubber from between the friction wheel plate.
1.
2.
3.
Drain the gasoline from the snow thrower, or
place a piece of plastic under the gas cap.
9.
Reassemble new friction wheel rubber to the
friction wheel assembly, tightening the six
screws in rotation and with equal force. It is
important to assemble the rubber on the friction
wheel symmetrically for proper functioning.
Tip the snow thrower up and forward, so that it
rests on the housing.
Remove six screws from the frame cover
10.
Insert the pin from the shift arm assembly into
15
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, Yard Man Snow Blower Manuals |
|---|---|
| Tags | MTD 31AE553F401, MTD 31AE573H401, MTD Snow Blower Manual, Yard Man 31AE553F401, Yard Man 31AE573H401 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | 31AE553F401, 31AE573H401, Yard-Man, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)