SECTION 5: SET-UP INSTRUCTIONS
NOTE: Reference to right or left side of the snow
thrower in this manual is from behind the unit in the
operating position.
sure all cables are aligned with cable roller
guides. See Figure 3.
IMPORTANT: Check the adjustments as
instructed on page 6, and make any final
adjustments necessary before operating your snow
thrower. Failure to follow the instructions may cause
damage to the snow thrower and void warranty.
1.
Remove the lower two plastic wing nuts, cupped
washers and carriage bolts from each side of the
lower handle. See Figure 1.
Check cables
on roller guides
Figure 3
5.
Secure the upper handle and lower handle with
the two plastic wing nuts, cupped washers and
carriage bolts previously removed. See Figure 4.
Wing
Nut,
Washer
Bolt
Figure 1
2.
3.
The chute crank may be attached to the lower
handle with cable ties for shipping purposes. If
so, cut the cable ties and remove the chute
crank at this time.
Wing Nut,
Cupped
Washer,
Upper
Handle
Raise the upper handle assembly until it locks
over the lower handle. See Figure 2.
Carriage
Bolt
Lower Handle
Figure 4
Move
handle
up
6. Slide the shift rod connector down over the end
of the lower shift rod. See Figure 5. Tap the
connector until it locks on the lower shift rod.
Upper Shift
Rod
Connector
Chute
Crank
Lower Shift
Rod
Insert hairpin
clip
Figure 2
4.
Look at lower rear of snow thrower frame to be
Figure 5
5
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, Yard Man Snow Blower Manuals |
|---|---|
| Tags | MTD 31AE553F401, MTD 31AE573H401, MTD Snow Blower Manual, Yard Man 31AE553F401, Yard Man 31AE573H401 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | 31AE553F401, 31AE573H401, Yard-Man, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)