•
•
Secure with the bell washer and hex bolt removed
earlier.
Secure the frame cover with six self-tapping
screws. Put the snow thrower down to its normal
operating position.
.
Shift ArmSprockSprocketet
Assembly
Pin
Spacer
NOTE: If you placed plastic film under the gas cap, be
certain to remove it.
Hex
Shaft
Hex Hub
of Sprocket
Friction
Spacer
Wheel
Figure 24
SECTION 8: OFF-SEASON STORAGE
•
•
•
Remove all debris from the exterior of equipment.
Follow lubrication recommendations on page 12.
Always store the snow thrower in a clean, dry area.
WARNING: Never store engine with fuel in
tank indoors or in poorly ventilated areas,
where fuel fumes may reach an open flame,
spark or pilot light as on a furnace, water
heater, clothes dryer or other gas appliance.
NOTE: When storing any type of power equipment in
an unventilated or metal storage shed, care should be
taken to rust proof the equipment. Using a light oil or
silicone, coat the equipment, especially any chains,
springs, bearings and cables.
•
If unit is to be stored over 30 days, prepare engine
for storage as instructed in the engine manual.
Safety & Decorative Labels: Part Number and Location
17
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, Yard Man Snow Blower Manuals |
|---|---|
| Tags | MTD 31AE993I401, MTD Snow Blower Manual, Yard Man 31AE993I401 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Yard-Man, 31AE993I401, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)