6
Maintaining
Your Snow
Thrower
Changing Friction Wheel
Rubber
•
Drain the gasoline from the snow thrower,
or place a piece of plastic under the gas
cap.
Friction
Wheel
Assembly
•
•
Tip the snow thrower up and forward, so
Remove hex
that it rests on the housing.
screw and
washer
hexSlideshaft
Remove screws from the frame cover
underneath the snow thrower. See Figure
16.
Remove the right wheel from the axle.
Using a 3/4” wrench, hold the hex shaft
and remove the hex bolts and cupped
washer and bearing from left side of the
frame. Refer to Figure 32.
Holding the friction wheel assembly, slide
the hex shaft out of the right side of the
unit. The spacer on the left side of the
hex shaft will fall and the sprocket should
remain hanging lose in the chain.
Hex Shaft
•
•
•
Figure 3
•
•
Lshaftift thande fricthetiondrivewheeshaftl assassemblies.embly out between the axle
Remove four screws securing the friction wheel rubber
between the friction wheel plates. See Figure 33.
Discard old rubber.
Reassemble the new friction wheel rubber to the
friction wheel assembly, tightening the four screws
in rotation and with equal force. It is important to as-
semble the rubber on the friction wheel symmetrically
for proper functioning.
WARNING
The rubber on the fric-
tion wheel is subject
to wear and should be
checked after the first
•
25
hours of operation,
and periodically
thereafter. Replace
the friction wheel
rubber if any signs of
wear or cracking are
found.
•
Insert the pin from the shift arm assembly into the
friction wheel assembly and hold assembly in position.
Refer to Figure 34.
Friction Wheel
•
•
Slide the hex shaft through the right side of the
housing and through the friction wheel assembly.
Figure 33
Insert the hex shaft through the sprocket and the
spacer. Make certain that the chain engages both the
large and the small sprocket.
NOTE: If the sprocket fell from the snow thrower while
removing the hex shaft, place the sprocket on the hex
shaft. Position the hex hub of the sprocket toward the fric-
tion wheel when sliding the sprocket on to the hex shaft.
•
•
Secure with the cupped washer and hex bolt removed
earlier.
Secure the frame cover with self-tapping screws.
Put the snow thrower down to its normal operating
position.
NOTE:certain toIf youremoveplacedit. plastic film under the gas cap, be
Figure 34
19
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, Yard Man Snow Blower Manuals |
|---|---|
| Tags | MTD 769-03247, MTD Snow Blower Manual, Yard Man 769-03247 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Yard-Man, 769-03247, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)