Engine
Pulley
Brake
Bracket
Assembly
Auger Control
Belt
Large
Shoulder
Bolt
Pulley
Extension
Spring
Figure 18
Auger
Idler
Rod
Belt
Keepers Belleville Washer
Hex Screw
Figure 21
Ferrule
Proper Adjustment With the auger clutch lever in
the disengaged position the top surface of the new
belt should be even with the outside diameter of the
pulley. To adjust, disconnect ferrule from the brake
bracket assembly and thread ferrule in (towards
idler) to increase tension on belt, out to decrease
tension.
Brake
Bracket
Assembly
Cable
Roller
Guide
“
Z”
Fitting
NOTE: The brake puck must always be firmly
seated in the pulley groove when the auger clutch
lever is in the disengaged position.
Figure 19
Auger
Housing
Drive Belt
Remove
Screw
Lock Washer
1.
Unhook extension spring from the belt cover
plate. See Figure 18.
Frame Assembly
2.
Remove drive belt from the engine pulley and
bottom drive pulley.
3.
4.
Replace belt and reassemble in reverse order.
Reassemble the two halves of the unit hooking
the lower portion of the auger housing over the
stationary shoulder bolts in the frame assembly.
Figure 20
5.
6.
Secure the two halves with the two screws and
lock washers
8.
9.
Separate the auger housing from the frame
assembly by tilting the housing forward and
pulling up the handles.
Attach the “Z” fitting of the cable into the brake
bracket assembly. See Figure 19.
Using a 1/2 ” wrench remove the hex screw and
belleville washer from the centre of the pulley on
the auger housing. Lift the brake bracket
assembly out of the pulley groove and remove
the pulley. See Figure 21. Be careful not to lose
the key.
7.
8.
Slip the auger control belt over engine pulley.
Insert ferrule on auger idler rod into bracket
assembly and secure with flat washer and cotter
pin.
9. Reassemble the large shoulder bolt and lock
washer as shown in Figure 18.
10.
11.
Remove and replace auger belt inside belt
keepers.
10. Reassemble belt cover and chute directional
control.
Reassemble pulley to auger housing with hex
screw and belleville washer (cupped is toward
the pulley). Be certain key is in place on shaft
and brake puck is seated in the pulley groove.
11. Remove plastic film from gas cap.
12
Categories | MTD Snow Blower Manuals, Snow Blower Manuals, Yard Man Snow Blower Manuals |
---|---|
Tags | MTD 993, MTD Snow Blower Manual, Yard Man 770-10278 |
Download File |
|
Document Type | Owner's Manual |
Language | English |
Product Brand | 993 Series, Yard-Man, Snow Blower |
Document File Type | |
Publisher | mtdproducts.com |
Wikipedia's Page | MTD Products |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)