Yard-Man 770-10278 993 Snow Blower Owners Manual by MTD

FINAL ADJUSTMENTS
Cable Guide
Auger and Traction Control Clutch
Adjustment
To check the adjustment of either drive clutch, push
forward   on  the   clutch  grip   (depress   the  rubber
bumper).   There   should   be  slack   in   the   cable.
Release   the   clutch   grip.  The   cable   should   be
straight, but not tight. Make certain you can depress
the clutch grip against the handle completely.
Figure 6  
If necessary, thread lock-nut up to increase tension
or down to decrease tension. See Figure 7.
11.
12.
13.
If not already attached, slip the cables that run
from the handle panel to the chute into the cable
guide located on top of the engine. See Figure
6.
Skid Shoe Adjustment (See Figure 8)
Unwrap the headlight wire which is attached to
the  headlight,  beneath  the  handle  panel.  Wind
the headlight wire around the right    handle until
excess slack is removed.
The space between the shave plate and the ground
can be adjusted. For close snow removal, place skid
shoes   in  the   low  position.   Use   middle  or   high
position  when  area  to  be  cleared  is  uneven.  See
Figure 8.
Adjust skid shoes by loosening the six hex nuts and
carriage  bolts  and  moving   skid  shoes  to  desired
position.  Make  certain  the  entire  bottom  surface  of
skid  shoe  is  against  the  ground  to  avoid  uneven
wear  on  the   skid  shoes.  Tighten  nuts   and  bolts
securely. The skid shoes  may be reversed  for even
wear.
Plug  the  wire  from  the  headlight  into  the  wire
lead  coming  from  the  right  side  of  the  engine,
underneath the fuel tank.
Cable
Shift Lever Adjustment (See Figure 9)
If unit does not engage properly into first gear, it may
be necessary to remove the cotter pin and washer
from   the   shift   rod  and   thread   the   ferrule   one
counterclockwise turn.
Lock Nut
Figure 7  
TIRE PRESSURE (Pneumatic Tires)
The  tires  are  over-inflated  for   shipping  purposes.
Check  tire  pressure  and  reduce  to  15  to  20  psi.
High
Middle
Low
(Check
sidewall
of
tire
for
manufacturer’s
recommendation)
Hex Nuts
Carriage Bolts
Skid
Shoe
NOTE: If the tire pressure is not equal in both tires,
the unit may pull to one side or the other.
Figure 8  
Ferrule
Flat Washer
Cotter Pin
Shift Rod
Figure 9  
6
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals, Yard Man Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 24 pages
Document TypeOwner's Manual
LanguageEnglish
Product Brand993 Series, Yard-Man, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website