Two-Way Chute Control™
Wheel Steering Controls
The two-way chute control is located on the left side of
the dash panel and is used to control the distance of snow
discharge from the chute.
The left and right wheel steering controls are located on
the underside of the handles. Squeeze the right control to
turn right; squeeze the left control to turn left.
•
To change the upper chute angle to control the
distance that snow is thrown, pivot the lever forward
or backward.
NOTE: Operate the snow thrower in open areas until you are
familiar with these controls.
Chute Clean-Out Tool
CHUTE DIRECTIONAL CONTROL
WARNING! Never use your hands to clear a
clogged chute assembly. Shut off engine and
CONTROLDIRECCIONALDELCANAL
remain behind handles until all moving parts
have stopped before unclogging.
DESCARGA
DISCHARGE
LEFT
DISCHARGE
RIGHT
DESCARGA A
A IZQUIERDA
A LA
DERECHA
The
L
chute
clean-out
rear of the auger housing with a mounting clip. Should
tool
is
conveniently
fastened to the
CHUTE TILT
DOWN
INCLINACIÓN DEL
CANAL HACIA
snow and ice become lodged in the chute assemblyABAJO
during
operation, proceed as follows to safely clean the chute
assembly and chute opening:
1
.
Release both the Auger Control and the Drive
Control.
Stop the engine by removing the ignitionCANAL HACIAkey.ARRIBA
CHUTE TILT
UP
INCLINACIÓN DEL
2
.
•
•
Move the lever forward to pivot the upper chute down 3. Remove the clean-out tool from the clip which
secures it to the rear of the auger housing.
and reduce the distance snow is thrown.
Move the lever rearward to pivot the upper chute
upward and increase the distance snow is thrown.
4. Use the shovel-shaped end of the clean-out tool
to dislodge and scoop any snow and ice which has
formed in and near the chute assembly.
Chute Directional Control
5
.
Refasten the clean-out tool to the mounting clip on
the rear of the auger housing, reinsert the ignition
key and start the snow thrower’s engine.
The chute directional control is located on the left side of
the snow thrower.
6
.
While standing in the operator’s position (behind the
snow thrower), engage the auger control for a few
seconds to clear any remaining snow and ice from the
chute assembly.
•
To change the direction in which snow is thrown,
crank clockwise to discharge to the left and
counterclockwise to discharge to the right.
1
sectiOn 4— cOntrOls and features
| Categories | Cub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Cub Cadet 930 SWE, Cub Cadet 933 SWE, MTD 930 SWE, MTD 933 SWE, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)