2
. Place chute assembly onto chute base as shown in Figure Headlight Harness
-4. Make sure that the chute notches engage with the
If not already done, wrap the wires of the headlight wire
spiral end of chute directional control, and the two flange harness around the lower right handle; then attach the
3
keepers are beneath the flange on the chute base.
wires to the engine as shown in Figure 3-7.
B
A
Figure 3-7
Figure 3-4
Set-Up
3
. Secure flange keeper removed earlier with lock nuts
and screws. Tighten down nuts securing the other two
flange keepers. See Figure 3-5.
Shear Pins
A pair of replacement auger shear pins and bow tie cotter pins
have been included with your snow thrower. There are holes
provided in the plastic dash panel for convenient storage of the
shear pins. Push the pins through the holes in the dash panel
and secure with the bow-tie cotter pins. See Fig. 3-8.
Figure 3-5
4
. Check that the chute cables are properly routed
through the cable guide on top of engine shroud. See
Figure 3-6.
Figure 3-8
Chute Clean-Out Tool
The chute clean-out tool is fastened to the top of the auger
housing with a mounting clip and a cable tie at the factory. Cut
the cable tie before operating the snow thrower. See Fig. 3-9.
Cable
Guide
Chute
Cables
Cleanout Tool
Figure 3-6
Figure 3-9
sectiOn 3 — asseMbly & set-up
7
| Categories | Cub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Cub Cadet 930 SWE, Cub Cadet 933 SWE, MTD 930 SWE, MTD 933 SWE, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)