7
Service
Belt Replacement
Belt Removal Preparation
Remove
1
2
3
. Disconnect the chute crank assembly at the discharge
chute end by removing the hairpin clip and the flat
washer. Refer to Figure 7-1.
Loosen
Figure 7-3
Auger Belt Replacement
To remove and replace your snow thrower’s auger belt,
proceed as follows:
1
. Remove the hairpin clip and flat washer from the
ferrule in order to disconnect the auger idler rod from
the brake bracket assembly. See Figure 7-4.
NOTE: Make sure to maintain the location of the ferrule
on the idler rod.
Figure 7-1
. Remove the plastic belt cover on the front of the
engine by removing the three self-tapping screws. See
Fig. 7-2.
Figure 7-4
Figure 7-
2
3
. Slip the auger control belt (the front belt) off the
engine pulley.
. Loosen the bolt shown in Figure 7-3 securing the belt
keeper bracket and remove the other bolt. Push the
belt keeper bracket up off the engine pulley. Refer to
Figure 7-3.
. Pull the brake bracket assembly towards the cable
guide roller and unhook the auger cable “Z” fitting.
Refer to Figure 7-5.
18
| Categories | Cub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Cub Cadet 930 SWE, Cub Cadet 933 SWE, MTD 930 SWE, MTD 933 SWE, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)