CRANKCASE AND CRANKSHAFT
Assembly
Seal assembly in the oil pump
B
C
1.
Place the oil pump on a sleeve (A) with
an inner diameter greater than the
seal’s outer diameter.
2.
Fit the seal (B) using the assembly
punch so that the surfaces (C), are
level.
A
Seal assembly in the plastic flange
1.
2.
Place the plastic flange on a flat and
firm surface.
Fit the seal using the assembly punch
until it bottoms on the flange shoulder.
Seal assembly in the crankcase
Some saws have a sharp edge on the crank-
shaft which can damage the seal. The as-
sembly sleeve should be used when working
on these saws. See ”Tools”.
1.
2.
Fit the seal using the assembly
mandrel.
The seal should be fitted using the
measurements for each saw as shown
in the instructions on the next page.
After fitting the seal assemble:
On the starter side:
•
•
•
Starter
Flywheel
Generator (if fitted)
On the clutch side:
•
•
Chain and bar
Oil pump
English –
123
| Categories | Chainsaw Manuals, Husqvarna Chainsaw Manuals |
|---|---|
| Tags | Husqvarna 242XP, Husqvarna 246, Husqvarna 254XP, Husqvarna 257, Husqvarna 262XP, Husqvarna 268, Husqvarna 268K, Husqvarna 272K, Husqvarna 272S, Husqvarna 272XP, Husqvarna 281XP, Husqvarna 288XP, Husqvarna 3120XP, Husqvarna 36, Husqvarna 394XP, Husqvarna 40, Husqvarna 41, Husqvarna 42, Husqvarna 45, Husqvarna 51, Husqvarna 55, Husqvarna 61 |
| Model Year | 1997, 1998, 1999, 2000, 2001, 2002 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Product Brand | Husqvarna, Chainsaw |
| Document File Type | |
| Publisher | husqvarna.com |
| Wikipedia's Page | Husqvarna |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)