2009-2011 Husqvarna CS2172WH CS2166 Chainsaw Owners Manual

FUEL HANDLING
Fuel
Mixing ratio
1:50
(2%) with JONSERED two-stroke oil.
Note! The machine is equipped with a two-stroke engine
and must always been run using a mixture of petrol and
two-stroke oil. It is important to accurately measure the
amount of oil to be mixed to ensure that the correct
mixture is obtained. When mixing small amounts of fuel,
even small inaccuracies can drastically affect the ratio of
the mixture.
1:33 (3%) with oils class JASO FB or ISO EGB formulated
for air-cooled, two-stroke engines.
Petrol, litre
Two-stroke oil, litre
2% (1:50)
0,10
3% (1:33)
5
0,15
0,30
0,45
0,60
WARNING! Always ensure there is
10
15
20
0,20
!
adequate ventilation when handling fuel.
0,30
0,40
Petrol
Mixing
Use good quality unleaded or leaded petrol. Engines
equipped with catalytic converters must be run on
unleaded fuel mixtures.
Always mix the petrol and oil in a clean container
intended for fuel.
Always start by filling half the amount of the petrol to
be used. Then add the entire amount of oil. Mix
(shake) the fuel mixture.Add the remaining amount of
petrol.
The lowest recommended octane grade is 90 (RON).
If you run the engine on a lower octane grade than 90
so-called knocking can occur.This gives rise to a high
engine temperature and increased bearing load,
which can result in serious engine damage.
Mix (shake) the fuel mixture thoroughly before filling
the machine’s fuel tank.
When working with continuous high revs (e.g.limbing)
a higher octane is recommended.
Environment fuel
JONSERED recommends the use of alkylate fuel, either
Aspen two-stroke fuel or environment fuel for four-stroke
engines blended with two-stroke oil as set out below.Note
that carburettor adjustment may be necessary when
changing the type of fuel (see the instructions under the
heading Carburettor).
Running-in
Do not mix more than one month’s supply of fuel at a
time.
Avoid running at a too high speed during the first 10
hours.
If the machine is not used for some time the fuel tank
should be emptied and cleaned.
Two-stroke oil
For the best results and performance use
JONSERED two-stroke oil, which is specially
formulated for our two-stroke engines.
Chain oil
JONSERED provides two stroke oils adapted for
different application areas and climates. Please
contact your dealer for information about the best
options for your product and area of application.
The chain lubrication system is automatic and we
recommend the use of special oil (chain oil) with good
adhesion characteristics.
Never use two-stroke oil intended for water-cooled
outboard engines, sometimes referred to as outboard
oil.
Never use oil intended for four-stroke engines.
Never use waste oil. This results in damage to the oil
pump, the bar and the chain.
English 17
Product Specification
CategoriesChainsaw Manuals, Husqvarna Chainsaw Manuals
Tags,
Model Year2009, 2010, 2011
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 44 pages
Document TypeOperator's Manual
LanguageEnglish
Product BrandHusqvarna, Chainsaw
Document File TypePDF
Publisherhusqvarna.com
Wikipedia's PageHusqvarna
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website