Checking the Interlock Switch
Operation
4.
5.
Move traction lever into Engage position, engine
must shut off.
If the engine does not shut off, the interlock
switch needs service. Correct the problem before
operating.
If safety interlock switches are disconnected
or damaged the machine could operate
unexpectedly causing personal injury.
6. Carefully lift up on handle to release kick stand.
Starting and Stopping the
Engine
•
•
Do not tamper with the interlock switches.
Check the operation of the interlock
switches daily and replace any damaged
switches before operating the machine.
Note: For illustrations and descriptions of the controls
referenced in this section, refer to the Controlws
section in Operation.
Traction Interlock Switch
Starting the Engine
1.
Push kick stand down with foot and pull up on
handle support until kick stand has rotated forward,
over center (Figure 22).
Note: Make sure spark plug wire is installed on spark
plug.
1.
Make sure traction and reel drive levers are in
Disengaged position.
Note: Engine will not start if traction lever is in
the engaged position.
2.
3.
4.
5.
Open the fuel shut-off valve on the engine.
Move the on/off switch to the On position.
Move the throttle control to the Fast position.
Move the choke lever to the half-open position
when starting a cold engine. The choke may not be
required when starting a warm engine.
6.
Pull the recoil starter handle out until positive
engagement results, then pull it vigorously to start
the engine. Open the choke as engine warms up.
Figure 22
1.
2.
3.
Kick stand
Important: Do not pull recoil rope to its limit
or let go of starter handle when rope is pulled
out because rope may break or recoil assembly
may be damaged.
Place traction lever into Engage position and engine
controls in starting position.
Attempt to start engine. Engine should not start.
If engine starts, the interlock switch needs service.
Correct the problem before operating. Refer to
Servicing Interlock Switch.
Stopping the Engine
1.
2.
3.
Move the traction and reel drive controls to the
Disengaged position, the throttle control to Slow,
and the on/off switch to Off.
4.
Carefully lift up on handle to release kick stand.
Brake Interlock Switch
Pull the molded spark plug wire off of the spark
plug to prevent the possibility of accidental starting
before storing machine.
1.
Push kick stand down with foot and pull up on
handle support until kick stand has rotated forward,
over center (Figure 22).
Close the fuel shut-off valve before storing or
transporting mower in a vehicle.
2.
3.
Start the engine.
Move the brake lever to the Engage position.
17
| Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
|---|---|
| Tags | Toro 04019, Toro 04024, Toro 04025, Toro 04202, Toro 04206, Toro 04207, Toro 04208, Toro Greensmaster |
| Model Year | 2010 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)