Stopping the Engine
1.
Move the throttle to the Slow position, and then to the
Stop position (Figure 28).
g018893
Figure 27
1.
2.
Electric-starter button
Electric starter plug-in
3. Recoil starter
Figure 28
Note: To use the electric starter, connect a power
cord to the electric starter plug-in first and then to a
power outlet. Use only a UL-listed, 16-gauge extension
cord recommended for outdoor use that is not longer
than 50 feet (15 m).
2. Wait for all moving parts to stop before leaving the
operating position.
3.
4.
Remove the ignition key.
Close the fuel shutoff valve by rotating it clockwise
(Figure 29).
WARNING
The electrical cord can become damaged,
causing a shock or fire.
Thoroughly inspect the electrical cord before
using the machine. If the cord is damaged,
do not operate the machine. Replace or repair
the damaged cord immediately. Contact an
Authorized Service Dealer for assistance.
Important: To prevent damaging the electric
starter, run it in short cycles (5 seconds maximum,
then wait one minute before trying to start it
again). If the engine still does not start, take
the machine to an Authorized Service Dealer for
service.
Figure 29
5.
Pull the recoil starter 3 or 4 times. This helps prevent
the recoil starter from freezing up.
8.
Disconnect the power cord from the power outlet first
and then from the machine (electric start only).
Operating the Traction Drive
9.
Allow the engine to warm up for several minutes, move
the choke toward the Run position. Wait for the engine
to run smoothly before each choke adjustment.
CAUTION
If the traction drive is not properly adjusted, the
machine may move in the direction opposite of
what you intended, causing injury and/or property
damage.
CAUTION
If you leave the machine plugged into a
power outlet, someone can inadvertently start
the machine and injure people or damage
property.
Carefully check the traction drive and adjust it
properly, if necessary; refer to Checking the Traction
Drive Operation in Setup for more information.
Unplug the power cord whenever you are not
starting the machine.
Important: If the machine moves when the traction
lever is in the released position, check the traction cable
16
| Categories | Snow Blower Manuals, Toro Snow Blower |
|---|---|
| Tags | Toro 37777, Toro Power Max 826 OTE |
| Model Number | 37777 |
| Model Year | 2015 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Serial Number | 315000001 - 315999999 |
| Product Name | Power Max 826 OTE Snowthrower |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Snow Blower |
| Product Type | Snowthrower |
| Product Series | Snowthrower, Two Stage Power Max |
| Swath | 26 inch |
| Discharge | Two Stage |
| Engine Manufacturer | Briggs & Stratton |
| Engine Oil Type | 18 oz. (.54l) 30w or 10w-30 / API SF or higher |
| Gearbox Lubricant | 4.5 oz. (133ml) SAE 90 GL5 or higher |
| Engine Motor Model # | 12D1050172F8 |
| Engine Motor Size | 205cc |
| Engine Motor Type | 4 Cycle |
| Engine Speed | 3300±100 RPM |
| Transmission Speed | 6 Forward/2 Reverse |
| Transmission Type | Friction Disc |
| Tire Pressure | 17-20 PSI / 116-137 kPa |
| Spark Plug | Champion QC12YC |
| Spark Plug Gap | .030"/ .76mm |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)