Discharge Chute Crank
Skid Shoes
IMPORTANT: If chute does not stay in set
position, adjust as directed in SERVICE AND
ADJUSTMENTS on page 18, or repair before
operation.
The skid shoes control the distance between
the scraper blade and the ground. Adjust skid
shoes equally to keep blade level with the
ground. Refer to Pre-Start on page 15 for
recommended settings.
Rotate the chute with the discharge chute
crank handle.
FILLING FUEL TANK
IMPORTANT: DO NOT force frozen chute
controls. If frozen, take to warm place until
controls are free.
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
Axle Lock Pin (Figure 10)
Use the axle lock pin to lock or unlock the
right or left wheel. Lock both wheels to
increase traction; unlock one wheel to allow
for easier turning of the unit.
GASOLINE
Fuel Recommendations
NOTE: Unit will not drive with both wheels
Use unleaded gasoline with a pump octane
rating of 86 or higher. These engines operate
best on unleaded gasoline.
unlocked.
Wheel Unlocked
CAUTION: Do NOT use stale or
contaminated gasoline or an
oil/gasoline mixture. Avoid getting dirt
or water in the fuel tank. Use only
proper fuel containers that are
properly marked.
CAUTION: DO NOT use E85
blended fuels. This engine is not
E20/E30/E85 compatible.
Axle Lock
Pin
Maximum recommended ethanol content:
10%
Adding a Fuel Stabilizer to Extend
Fuel Storage Life
NOTE: Fuel stabilizer is recommended for
long term storage.
1.
Turn the fuel valve off while engine is
running and allow the engine to run until
it stops. Turn engine OFF when it begins
surging to avoid engine damage.
2.
3.
4.
Add fuel stabilizer, following the
manufacturer’s instructions.
Turn fuel valve on after adding fuel
stabilizer.
Wheel Locked
Figure 10
Re-start engine.
Scraper Blade
5. Run the engine outdoors for 1 minute to
be sure that treated gasoline has
replaced the untreated gasoline in the
carburetor.
The scraper blade allows better contact with
the surface being cleared. It also prevents
damage to the housing from wear.
6.
Slow the engine to an idle speed.
IMPORTANT: DO NOT allow scraper blade to
wear too far or auger/impeller housing will
become damaged.
7. Repeat step 1 above.
To add fuel to fuel tank:
1.
ALWAYS place unit in open or well-
ventilated area.
2.
Stop engine and allow to cool.
GB - 14
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 920400, Ariens 920401, Ariens Sno-Tek 24, Ariens Sno-Tek 26 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(1 votes, average: 4 out of 4)
Lawn and Garden readers have rated Ariens Sno Tek 24 26 920400 920401 Snow Blower Owner Manual 4.0 out of 4.0 based on 1 product reviews. good site to find different manuals. Trying to download. hope it works.