SNOW REMOVAL
TRAVELING
IMPORTANT: Allow unit and engine to adjust
to the outdoor temperature before clearing
snow.
To travel from one work area to another:
1.
Set Throttle to Slow or Part-Throttle
position.
NOTE: Attachment clutch should be engaged
before wheel drive clutch when throwing
snow.
2. 921011, 012, 013, 017, 018, 019, 020:
Press down on handlebars enough to
raise front of unit slightly off surface.
1.
2.
3.
Select Speed Control position and
direction.
Engage Attachment Clutch - Right Hand
Lever.
Engage Traction Drive Clutch - Left
Hand Lever.
921014, 015, 016: Place the unit in the
transport position (see Track Angle on
page 20).
3. Engage wheel or track drive clutch
without engaging attachment drive
clutch.
IMPORTANT: DO NOT overload unit capacity
by attempting to clear snow at too fast a rate.
Use slow speed to clear deep or hard packed
snow.
TRANSPORT
ALWAYS shut off engine, remove key, and
close fuel shut-off valve when transporting
unit on a truck or trailer.
Tips for Operation
Snow is best removed as soon as possible
after snow fall.
Use extra care when loading or unloading
unit onto trailer or truck.
Secure unit chassis to transport vehicle.
NEVER secure from rods or linkages that
could be damaged.
To clear an area, run unit in an overlapping
series of paths. For large areas, start in the
middle and throw snow to each side, so snow
is not cleared more than once.
DO NOT transport machine while engine is
running.
ALWAYS direct snow away from area to be
cleared and with direction of the wind.
MAINTENANCE
Ariens Dealers will provide any service or
adjustments which may be required to keep
your unit operating at peak efficiency. Should
engine service be required, contact an Ariens
dealer or an authorized engine
Service Position
manufacturer's service center.
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
SERVICE POSITION
WARNING: Before tipping unit up
onto housing, remove fuel so no
spills will occur. Ensure unit is
secure and will not tip over during
maintenance.
Place unit on a flat level surface. Tip unit
forward onto front of auger housing for
service. Ensure unit is secure and will not tip
over. Strap and clamp onto bench if needed.
Figure 24
OS7121
GB - 23
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 921011, Ariens 921012, Ariens 921013, Ariens 921014, Ariens 921015, Ariens 921016, Ariens 921017, Ariens 921018, Ariens 921019, Ariens 921020, Ariens 932105, Ariens 932506, Ariens Deluxe 24, Ariens Deluxe 24 Platinum, Ariens Deluxe 27, Ariens Deluxe 30, Ariens Deluxe 30 Platinum, Ariens Deluxe Track 24, Ariens Deluxe Track 27, Ariens Deluxe Track 30, Ariens Snow Blower Manuals |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)