Ariens Sno Thro 921011 12 13 14 15 16 17 18 19 20 Deluxe Track Platinum Snow Blower Owners Manual

IMPORTANT: If traction clutch cannot be
adjusted within specified range, see your
Dealer for repairs.
CAUTION: Always support Sno-
Thro frame and blower housing
when loosening the cap screws
holding them together. Never
loosen cap screws while unit is in
service position.
8.
9.
Remove hex bolts securing housing to
frame (two on each side). Tip housing
and frame apart on pivot pin (Figure 45).
Remove attachment drive belts from
attachment pulley (hold brake away from
belt).
921011,
012, 013, 014,
015,
016, 019, 020
2
3
1
>
1/32 in.
OS7144
(.8 mm)
Figure 44
ATTACHMENT DRIVE BELT
REPLACEMENT
Remove old attachment drive belts:
1.
Shut off engine, remove key, disconnect
spark plug wire and allow unit to cool
completely.
921017,
018
2.
3.
Remove belt cover and chute gear cover
3
(921017, 018) (Figure
45).
2
Rotate discharge chute all the way to the
left (as viewed from the operator’s
position).
921017, 018: Remove hair pin under the
control panel connecting the discharge
chute rod to the chute rotation lever and
slide the discharge chute rod forward.
1
4.
4
921011, 012, 013, 014, 015, 016, 019,
020: Remove spring pin from chute
crank and separate.
IMPORTANT: Disconnect chute lock cable
and deflector cable, if equipped (921017,
018).
1.  Belt Cover
2.  Chute Gear Cover
5.
6.
Remove belt finger (Figure 41).
3.  Discharge Chute Rod
4.
Chute Lock Cable
Remove attachment drive belt from
engine sheave (it may be necessary to
turn engine sheave using recoil starter
handle).
Figure 45
Install new attachment drive belts:
Place new attachment belts onto
attachment pulley.
NOTE: Holding down the attachment clutch
lever will make it easier to reconnect the
housing and frame.
Tip housing and frame back together
and secure with hex bolts.
IMPORTANT: To avoid bending bottom cover
when tipping unit apart, support handlebars
firmly or tip unit up on housing and remove
bottom cover by removing six cap screws
before separating unit.
1.
7.
Support Sno-Thro frame and housing.
2.
3.
Place belts onto engine sheave.
GB - 32
Product Specification
CategoriesAriens Snow Blower Manuals, Snow Blower Manuals
Tags, , , , , , , , , , , , , , , , , , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 44 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandAriens, Snow Blower
Document File TypePDF
Publisherariens.com
Wikipedia's PageAriens
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website