MAINTENANCE SCHEDULE
Wheels must stop quickly when traction drive
clutch lever is released.
The chart below shows the recommended
maintenance schedule that should be
performed on a regular basis. More frequent
service may be required.
If clutches do not engage or disengage
properly, adjust or repair before operation.
See Attachment Clutch/Brake Adjustment on
page 29 and Traction Drive Clutch
Adjustment on page 32.
MAINTENANCE
SCHEDULE
CHECK CLUTCH SPRING
ADJUSTMENT
Make sure the attachment clutch and traction
drive clutch are adjusted to the range
specified in Check Clutch Spring Adjustment
on page 25.
Service
Performed
Each Every Every Yearly
Use 5 hrs. 25
hrs.
Check Dual
Handle
Interlock
•
CLEAN ENGINE
Refer to Engine Manual for detailed
instructions.
Check
•
•
Fasteners
Check Clutch
Operation
CHECK ENGINE OIL
Check Clutch
Spring
Adjustments
*
•
The engine crankcase oil should be checked
every 5 hours of operation. Oil level MUST be
maintained in safe operating range on
dipstick at all times or engine damage will
result (See Engine Manual).
Clean Engine
•
•
Check Engine
Oil
•
Park unit on a level surface. Refer to Engine
Manual for detailed instructions.
Change
Engine Oil
** **
•
CHANGE ENGINE OIL
Check Tire
Pressure
•
Change oil after first 2 hours of operation,
thereafter change oil every 25 hours (more
often if required). Refer to Engine Manual for
detailed instructions.
Check Auger
Gearcase
•
•
•
•
General
Lubrication
Run engine just prior to changing oil. Warm
oil will flow more freely and carry away more
contamination. Remove the oil drain plug
from the rear of the unit and tip the unit back
to help drain all the oil. 921019, 020-Remove
right wheel to allow better access to oil drain.
*
After first five hours of operation.
**
After first two hours of operation,
thereafter every 25 hours.
CHECK DUAL HANDLE
INTERLOCK
Without the engine running, press down
(engage) both clutch levers. Release
attachment clutch lever. Attachment clutch
should remain engaged until traction clutch
lever is released, then both clutches must
disengage.
CHECK TIRE PRESSURE
(
921011, 012, 013, 017, 018, 019,
)
020
Keep tires at pressure listed on the tire
sidewall. See Check Tire Pressure on
page 12.
CHECK AUGER GEARCASE
CHECK FASTENERS
Make sure all hardware is tightened properly.
IMPORTANT: Proper oil level must be
maintained.
Gear cases are filled to the correct level at
the factory. Unless there is evidence of
leakage, no additional lubricant should be
required. Check oil level each season or
every 25 hours of operation.
CHECK CLUTCH OPERATION
Auger / impeller must stop within 5 seconds
when attachment clutch/impeller brake lever
is released.
GB - 24
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 921011, Ariens 921012, Ariens 921013, Ariens 921014, Ariens 921015, Ariens 921016, Ariens 921017, Ariens 921018, Ariens 921019, Ariens 921020, Ariens 932105, Ariens 932506, Ariens Deluxe 24, Ariens Deluxe 24 Platinum, Ariens Deluxe 27, Ariens Deluxe 30, Ariens Deluxe 30 Platinum, Ariens Deluxe Track 24, Ariens Deluxe Track 27, Ariens Deluxe Track 30, Ariens Snow Blower Manuals |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)