OPERATION
Speed Selector
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
Position the Speed Selector in the appropriate speed
notch to control forward and reverse travel.
WARNING: To avoid injury to hands and feet,
always disengage clutches, shut off engine,
and wait for all movement to stop before
unclogging or working on snow thrower.
Keep hands and feet away from auger and
impeller.
1
2
6
5
4 3 2 1
OS2401
Forward:
Reverse:
CONTROLS AND FEATURES
See Figure 7 for all Controls and Features locations.
(6) Fastest
(1) Slowest
Traction Drive Clutch - Left Hand Lever
Squeeze the Traction Drive Clutch
Lever against the Handlebar (1) to
(1) Slow
(2) Fast
2
engage wheel drive for propelling
unit. Forward speed will vary
according to snow depth and
IMPORTANT: DO NOT change motion from forward to
reverse with clutch engaged. Forward speed can be
changed without declutching.
moisture content.
1
Release lever (2) to stop movement.
OL2701
Choke Control Knob
NOTE: When traveling to or from the
area to be cleared, press down on the handlebars
enough to raise the front of the unit slightly off the
surface. Engage the traction drive clutch without
engaging the attachment drive clutch.
1. Choke Closed position: chokes off
air to engine for easier start.
2
2. Choke Open position: allows for
1
normal operation.
IMPORTANT: Gradually open choke
after engine starts.
Attachment Clutch - Right Hand Lever
Squeeze Attachment Clutch Lever
2
OS1332
against handlebar (1) to engage
attachment. Release both clutch
levers (2) to disengage power and
apply brake to attachment.
Throttle
The throttle controls the engine speed. To
increase or decrease the engine speed,
adjust to:
1
2
1
IMPORTANT: If the belt squeals
when the attachment clutch lever is
engaged, the impeller may be frozen
in the auger housing. Immediately
1. Fast (normal or warm starts)
2. Part-Throttle
OL2691
3
3. Slow (cold weather starts)
4. Stop (engine is off) (Not on 12V models)
4
STOP
release the attachment clutch lever and move the unit
into a heated area to thaw.
OL2720
Electric Starter (120V electric start models)
NOTE: If belt squeals when impeller turns freely, see
Attachment Drive Belt Replacement on page 19.
The electric starter will start a properly choked and
cranked engine when the starter button is pushed.
Refer to Starting and Shut Off on page 14.
Ignition Switch (120V start on engine)
Key Switch has two positions:
1. “Stop” - pulled out
Recoil Starter Handle
When pulled, handle will turn engine over.
2
2. "Run" - pushed in
IMPORTANT: DO NOT let handle snap back against
starter.
NOTE: DO NOT twist key after it is
inserted.
1
OS1431
Primer Bulb
Pushing the primer bulb in adds fuel for
easier engine start. Refer to Starting and
Shut Off on page 14.
OS1321
GB - 12
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 932040, Ariens 932041, Ariens 932042, Ariens 932140, Ariens 932141, Ariens 932509, Ariens 932510, Ariens 932511, Ariens ST5520, Ariens ST5520E, Ariens ST624, Ariens ST624E, Ariens ST7524, Ariens ST7524E |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)