Snow Clean-Out Tool (Figure 8)
Chute Handle (932040, 140)
IMPORTANT: If chute does not stay in set position,
adjust as directed in SERVICE AND ADJUSTMENTS
on page 18, or repair before operation.
WARNING: Hand contact with the rotating
impeller is the most common cause of injury
associated with snow throwers. Never use
your hand to clean out the discharge chute.
Rotate the Chute with Discharge Chute Handle.
Always stand opposite the direction of snow discharge
when rotating the discharge chute.
1
IMPORTANT: DO NOT force frozen chute controls. If
still frozen, take to warm place until controls are free.
Axle Lock Pin (Figure 9)
Use the axle lock pin to lock or unlock the right or left
wheel. Lock both wheels to increase traction; unlock
one wheel to allow for easier turning of the unit.
NOTE: Unit will not drive with both wheels unlocked.
Wheel Unlocked
Figure 8
To clear the chute:
1.
2.
Shut off the engine.
Wait 10 seconds and make sure impeller blades
have stopped rotating.
3.
4.
Remove the snow clean-out tool (1) from the
auger housing and use it to remove the clog.
Replace the snow clean-out tool on the auger
housing.
Axle Lock Pin
Wheel Locked
Discharge Chute Deflector
ALWAYS position discharge chute deflector at a safe
angle before starting engine.
DO NOT throw snow any higher than necessary.
Push deflector handle forward or down to throw snow
lower. Pull deflector handle up or to the rear to throw
snow higher.
IMPORTANT: If Chute Deflector does not stay in set
position, adjust as directed in SERVICE AND
ADJUSTMENTS on page 18, or repair before
operation.
Figure 9
Scraper Blade
The scraper blade allows the back of the housing to
keep better contact with the surface being cleared. It
also prevents damage to the housing from normal
wear.
Discharge Chute
Discharge chute rotates 195°.
ALWAYS position discharge chute in safe direction and
angle, away from operator and bystanders, before
starting engine.
IMPORTANT: DO NOT allow Scraper Blade to wear
too far or Auger/Impeller housing will become
damaged.
Chute Crank (932041, 042, 141, 509, 510, 511)
Runners
IMPORTANT: If chute does not stay in set position,
adjust as directed in SERVICE AND ADJUSTMENTS
on page 18, or repair before operation.
The runners control the distance between the scraper
blade and the ground. Adjust runners equally to keep
blade level with the ground. Refer to Pre-Start on
page 14 for recommended settings.
Rotate the Chute with Discharge Chute Crank Handle.
IMPORTANT: DO NOT force frozen chute controls.
Start engine and run for 3-5 minutes to thaw. If still
frozen, take to warm place until controls are free.
GB - 13
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 932040, Ariens 932041, Ariens 932042, Ariens 932140, Ariens 932141, Ariens 932509, Ariens 932510, Ariens 932511, Ariens ST5520, Ariens ST5520E, Ariens ST624, Ariens ST624E, Ariens ST7524, Ariens ST7524E |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)