Ariens Sno Thro Models 932105 932506 Snow Blower Service Manual

Ariens dealers will provide any service or adjustments
which may be required to keep your unit operating at
peak efficiency. Should engine service be required,
contact an Ariens dealer or an authorized engine
manufacturer's service center.
7.  Grasp starter handle and pull rope out slowly until it
pulls harder. Let rope rewind slowly.
8.
Pull rope with a rapid continuous full arm stroke.
Let rope rewind slowly.
IMPORTANT: DO NOT let starter handle snap against
starter.
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
9.
Repeat steps 7 and 8 until engine starts. (If engine
does not start, refer to Troubleshooting.)
10.Adjust choke as needed.
4.2
SERVICE POSITIONS
11.Set throttle to PART THROTTLE or SLOW position
for adaptation to outside temperature or travel. Set
throttle to FAST position for normal operation.
WARNING: Before tipping unit up onto housing,
remove fuel so no spills will occur and remove
battery (if equipped). Ensure unit is secure and
will not tip over during maintenance.
Electric Start
1.
Connect extension cord to prongs on starter.
Place unit on a flat level surface. Tip unit forward onto
front of impeller housing for service. Assure unit is
secure and will not tip over. Strap and clamp onto
bench if needed.
IMPORTANT: Prevent damage to unit. Know voltage of
your starter and only use matching outlets.
2.
Plug extension into 120V or 240V 3-wire, grounded
outlet.
3.
4.
Turn discharge chute straight ahead.
4.3
TO STOP IN AN EMERGENCY
Make sure that the traction clutch and attachment
drive clutch levers are fully disengaged.
Immediately release both control levers to stop unit in
an emergency. Stop engine, remove key and wait for
all rotating parts to stop before leaving operator’s
position.
5.
Push primer bulb 2 or 3 times for cold engine.
NOTE: When temperature is below -15° F (-26° C)
additional priming may be needed.
4.4
STARTING AND SHUT OFF
6.
Insert key into ignition switch on engine and push
into RUN position. DO NOT twist key after it is
inserted.
WARNING: FAILURE TO FOLLOW
INSTRUCTIONS could result in personal injury
and/or damage to unit. DO NOT attempt to start
your unit at this time. Read entire Owner/
Operator Manual and the Engine Manual first.
7.
If engine is cold, apply choke. A warm engine
requires less choking than a cold engine. See
Engine Manual for detailed instructions.
8.
9.
Set throttle to proper starting position.
IMPORTANT: Allow unit and engine to adjust to the
outdoor temperatures before clearing snow. Before
shut-off, run the attachment a few minutes to prevent
freeze-up.
Press starter button on engine until engine starts.
IMPORTANT: DO NOT operate starter more than 15
seconds per minute, as overheating and damage can
occur. (If engine does not start, refer to
Troubleshooting.)
IMPORTANT: Try out each control without the engine
running to see how it works and what it does.
10.Adjust choke as needed.
Manual Start
11.Disconnect power cord from outlet, then starter.
1.
2.
Turn discharge chute straight ahead.
12.Set throttle to PART THROTTLE or SLOW position
for travel or adaptation to outside temperature.
Once achieved, set throttle to FAST position for
normal operation.
Make sure that the traction clutch and attachment
drive clutch levers are fully disengaged.
3.
Push primer bulb 2 or 3 times for cold engine.
NOTE: When temperature is below -15° F (-26° C)
additional priming may be needed.
Shut Off
1.
2.
3.
Release traction drive clutch lever and allow unit to
come to a complete stop.
4.
If engine is cold, apply choke. See Engine Manual
for detailed instructions.
Run Impeller a few minutes after use to prevent
freeze-up of Impeller.
NOTE: A warm engine requires less choking than a
cold engine.
Release attachment clutch lever and wait for all
moving parts to come to a complete stop.
5.
6.
Set throttle to proper starting position.
Insert key into ignition switch and push into RUN
position. DO NOT twist key after it is inserted.
4.
5.
Move throttle to the STOP position.
Remove key.
4
- 13
Product Specification
CategoriesAriens Snow Blower Manuals, Snow Blower Manuals
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 34 pages
Document TypeService Manual
LanguageEnglish
Product BrandAriens, Snow Blower
Document File TypePDF
Publisherariens.com
Wikipedia's PageAriens
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website