SECTION 10 - AUGER/IMPELLER
10.1
AUGER/IMPELLER REMOVAL
Occasionally an object may enter auger/impeller
housing and jam auger, breaking shear bolts which
secures auger to shaft. This allows auger to turn freely
on shaft preventing damage to gear drive.
Place unit in the belt service position.
1.
2.
3.
Remove bolt holding auger driven pulley to shaft
and remove pulley.
To replace shear bolt:
Remove three nuts holding bushing flange to
housing and remove flange on each side.
1.
2.
3.
Slide auger outward against roll pin and align hole
in shaft with hole in auger (Figure 23). The holes in
shaft for roll pins and shear bolts will line up.
Grasp auger assembly and pull gear case and
auger/impeller assembly free of housing.
Drive the new shear bolt through hole (if shear bolt
was broken this will drive remaining part from
shaft).
4.
5.
6.
Remove shear bolts and remove auger from shaft.
Check all parts for wear or replacement.
Assemble using reverse procedure.
Secure with nut.
10.2
SHEAR BOLTS
WARNING: Stop engine, remove key, wait for
moving parts to stop and remove wire from
spark plug before leaving operator’s position
and attempting to maintain or inspect auger.
IMPORTANT: Use only Ariens shear bolts for
replacement. Use of any other type of shear bolt may
result in severe damage to unit.
4
3
5
1.
2.
3.
4.
5.
Scraper Blade
Shear Bolt
Runner
Drift Cutter
Bushing
1
2
PS0711
Figure 23
10
- 28
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)