SECTION 5 - SERVICE AND ADJUSTMENTS
5.2
DISCHARGE CHUTE
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
If chute does not stay in position while operating,
tighten nut on carriage bolt at pivot point to increase
tension on spring (Figure 10).
5.1
DEFLECTOR REMOTE
Smooth and easy rotation of properly lubricated chute
with crank is obtained by adjusting pinion and chute
gear teeth so they mesh together.
Deflector must stay in selected position while throwing
snow.
If deflector does not stay in set position:
1.
Tighten nut beneath the control panel to increase
friction on pressure flange (Figure 9).
1
2
4
3
1
2
1.
2.
Pinion
Chute Gear
3. Carriage Bolt
4. Spring
OS6730
Figure 10
4
5.3
RUNNERS
3
Runners should be adjusted (Figure 11) as conditions
require.
1.
2.
Position unit on a hard, flat, smooth level surface.
Adjust runners by inserting a spacer of desired
thickness under center of scraper blade, loosen
runner hardware, slide runners to flat surface.
Allow 1/8 in. (3 mm) between scraper blade and
hard smooth surfaces. Allow 1-1/4 in. (30 mm)
between scraper blade and uneven or gravel
surfaces. Retighten hardware.
1
2
. Nut
. Pressure Flange
3.
4.
Adjusting Nuts
Cable Support Bracket
OS6700
Figure 9
If deflector does not follow full range of travel:
NOTE: Keep housing level by adjusting runners
equally.
1.
2.
3.
Push deflector remote all the way forward.
Loosen adjusting nuts on cable support bracket.
To adjust the deflector lower, slide cable down.
Tighten bottom nut.
4.
5.
To adjust deflector higher, slide cable up. Tighten
top nut.
Check travel and repeat adjustment as necessary.
5
- 18
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)