SERVICE AND MAINTENANCE
Remove
Loosen
Figure 25
Figure 24
See Figure 26.
NOTE: Make sure that the location of the ferrule on the auger
idler rod is maintained.
2
3
.
.
Slip the auger control belt (the front belt) off the engine pulley.
Pull the brake bracket assembly towards the cable guide roller
and unhook the auger cable “Z” fitting. See Figure 27.
From both sides of the the frame assembly, use a 1/2” wrench to
remove the three hex tap screws securing the frame to the auger
housing assembly. Refer to Figure 23 on previous page.
NOTE: Do not remove the lower hex flange lock nut on each side.
Place a block of wood underneath the auger housing as shown in
Figure 28 and separate auger housing from the frame by tilting the
housing forward and pulling up the handles.
4.
5.
6.
Block the impeller with a piece of wood to prevent it from spinning
and use a 1/2” wrench to remove the hex screw and flat washer
from the center of the pulley on the auger housing. See Figure 29.
Lift the brake bracket assembly out of the pulley groove and slide
the pulley assembly off the posts of the auger pulley adapter to
remove the old belt. Refer to Figure 29.
7.
Figure 26
NOTE: The pulley adapter may slide off the auger input shaft when
removing the pulley. Use extra caution to ensure the adapter does fall
and/or get damaged when removing the pulley.
8.
Placeplace thethe pulleynew augerw/beltbeltinsidein thetheV-groovebelt keepers.of the auger pulley and
9.
Turn the pulley as necessary to align its three slots approximately
with the posts of the pulley adapter, then move the brake bracket
assembly away from the input shaft. While aligning the pulley
slots and adapter posts, push the auger pulley fully onto the
adapter. Refer to Figure 29.
NOTE: If the pulley adapter was removed with the pulley, align the
splines of the pulley adapter and auger input shaft, and push the pulley
and adapter onto the input shaft. Refer to Figure 29.
10.
Slide the washer onto the hex screw removed earlier and apply
Loctite 262 to the threads of the hex screw.
Figure 27
11.
Insert the hex screw through the pulley assembly and into the
20
| Categories | Craftsman Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Craftsman 24788845 |
| Model Number | 247.88845 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English, Español |
| Product Name | Craftsman 45-Inch |
| Product Brand | Craftsman. Customer Service Representatives are available by phone: Canada 1-888-225-4886 USA 1-888-384-9939, Snow Blower |
| Product Type | Snowthrower |
| Swath | 45 inch |
| Engine Oil Type | SAE 5W30, 4-Cycle Engine Oil (Quart) Recommended for Temperature: - Above 32°F: SAE 30W Straight Grade; - 0°F to 32°F: SAE 5W-30 or SAE 10W-30 Multi Grade; - Below O°F: SAE 0W-30 Synthetic |
| Document File Type | |
| Publisher | craftsman.com |
| Wikipedia's Page | Craftsman (tools) |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)