OPERATION
Operating t ips
Always:
1.
2.
Use clean fluid and check fluid level regularly.
Use an approved hydraulic fluid. Approved fluids include Dexron®
III / Mercon® III automatic transmission fluid, a 10 Weight AW
hydraulic oil or Pro-Mix™ AW-32 Hydraulic Oil.
3.
4.
5.
6.
Use a filter (clean or replace regularly).
Use a breather cap on fluid reservoir.
Make sure pump is mounted and aligned properly.
Use a flexible “spider” type coupling between engine and pump
drive shafts.
7.
Keep hoses clear and unblocked.
8.
Bleed air out of hoses before operating.
9.
Flush and clean hydraulic system before restarting after servicing.
Use “pipe dope” on all hydraulic fittings.
Figure -
10.
11.
12.
3.
4.
5.
SupportSee Figurethe4-4.tongue and pivot the jack stand up against the tongue.
Allow time for warm-up before splitting wood.
Primewith sparkthe pumpplug disconnected.before initial start-up by turning over the engine
SecureFigure 4-4.with the spring clip and clevis pin previously removed. See
Attachvehicle;couplerlatch securely.hitch to a class I or higher 2” ball on a towing
13.
Never:
Split wood along the grain (lengthwise) only.
1.
Use when fluid is below 20° F or above 150° F.
a. If coupler hitch does not fit on ball: Turn adjustment nut one
2
. Use a solid engine /pump coupling.
turn counter-clockwise.
b. If coupler hitch is too loose on ball: Turn adjustment nut one
turn clockwise.
3.
4.
Operate through relief valve for long.
Attemptgauges. to adjust unloading or relief valve settings without pressure
6.
7.
Connect the safety chains to the towing vehicle.
Plugthe towin thevehicle.tail lights, if so equipped, to the tail light connector on
5.
6.
7.
Operate with air in hydraulic system.
Use teflon tape on hydraulic fittings.
Attempt to cut wood across the grain.
WaRninG
Do not tow faster than 45mph and check local, state, and federal
8.
Attempt to remove partially split wood from the wedge with your
requirements before towing on any public road.
NOTEspotter: outsideUse cautionthe vehicle.when backing up. It is recommended to use a
hands. Fully retract wedge to dislodge wood with log dislodger.
t RanSPORt inG t he LOG SPLit t eR
IMPORTANT: Always turn fuel valve to OFF position before transport-
ing the log splitter.
1.
Lower the beam to its horizontal position. Make certain the beam is
locked securely with the horizontal beam lock.
2.
Remove spring clip and clevis pin from jack stand.
11
Categories | Craftsman Lawn Mower Manuals, Lawn Mower Manual |
---|---|
Tags | Craftsman 675 247.77640 |
Download File |
|
Document Type | Operator's Manual |
Language | English |
Product Brand | Craftsman. Customer Service Representatives are available by phone: Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | craftsman.com |
Wikipedia's Page | Craftsman (tools) |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)