MTD 140 152 Snow Blower Owners Manual

SECTION 9:  MAINTENANCE
WARNING:  NEVER  attempt to clean  chute or make any  adjustments or repairs  while engine
is running.
NOTE:  Check engine and snow thrower frequently for loose nuts, bolts, etc., and keep these items tightened.
ENGINE
Refer  to  the separate  Engine  Operator’s  Manual  packed with  your  snow  thrower  for all  engine  maintenance
procedures.
SHAVE PLATE REPLACEMENT
The shave plate is subject  to wear. It should be checked periodically. There are two wearing edges and  the shave
plate can be reversed. Refer to Figure 13.
To remove the shave plate:
1.
2.
3.
4.
Remove the four carriage bolts and hex lock nuts which attach it to the snow thrower housing.
Install new shave plate, making sure the heads of the carriage bolts are on the inside of the housing.
Adjust the shave plate according to procedure in the “Adjustment” section of this manual.
Tighten securely.
BELT REPLACEMENT
Idler Pulley
Engine
Pulley
Auger
Pulley
Hex
Belt
Screws
Figure 15
Remove the belt cover by removing five hex screws. See Figure 15.
1.
2.
3.
4.
5.
Pull up on the idler pulley and slip the belt off engine pulley.
Push down on idler pulley and slip the belt off auger pulley.
Reassemble new belt in reverse order.
Reinstall the belt cover.
13
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 24 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website