MTD 140 152 Snow Blower Owners Manual

SECTION 4:  UNPACKING INSTRUCTIONS
See Figure 3.
Remove staples, break glue on  the top flaps of the carton or cut tape  at carton end and peel along top flap
to open carton. Remove any loose parts included with unit (i.e., Operator’s manual, etc.).
Cut along dotted lines and lay end of carton down flat. Remove packing material.
Roll unit out of carton. Check carton thoroughly for loose parts.
PUSH
REMOVE MANUAL & LOOSE PARTS
Figure 3
SECTION 5:  SET- UP INSTRUCTIONS
This Operator’s  Manual covers  several models of  snow throwers.  Much of the  Manual pertains  to all  of
the models.  However, there are  some areas where  only one model  is covered. Use  only the information
that is appropriate for your model.
ITEMS REQUIRED FOR SET-UP
Pair of pliers (not necessary, but helpful)
2 cycle oil
Fresh Gasoline
IMPORTANT: This  unit   is  shipped  WITHOUT  GASOLINE   or  OIL.  See  separate   Engine  Operator’s
Manual for proper fuel and two cycle engine oil recommendations.
Note:  Reference to right or left hand side of the snow thrower is from the operating position
CONTENTS OF HARDWARE PACK
(2) Ignition Keys (One may be in the switch on snow thrower)
Models 150 thru 152 and  model 140 with Optional Extended Chute Crank:
(1)  Eyebolt
(1)  Saddle Washer 5/16" I.D.
(2)  Hex Nuts 5/16-18 Thread
(1)  Cotter Pin
5
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 24 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website