MTD 140 152 Snow Blower Owners Manual

SECURE FROM THE UNDERSIDE.
See Figure 8.
1.
Place a piece  of the  cardboard from  the carton on a level  surface. Tip the snow  thrower forward so that the
housing rests on the cardboard from the box.
2.
3.
4.
Thread one 5/16” hex nut all the way onto the eyebolt.
Slide the eyebolt onto the chute crank. Insert eyebolt into the hole in the lower handle.
Insert the  chute crank into the  hole provided in  the snow thrower  cover. Place the  end of the  crank into the
coupler located inside the snow thrower.
5.
6.
Rotate the crank to align  holes, and insert the cotter pin (inside  the snow thrower cover). Bend ends of cotter
pin in opposite directions to secure.
Secure eyebolt with  5/16” saddle washer  and hex nut.  The Cupped side of  washer goes against  the handle
Adjust lower hex nut until the eyebolt is positioned so the chute crank turns freely (does not bind).
7.
8.
Move upper hex nut down against the lower handle.
Tighten lower hex nut securely.
Chute Crank
Coupler
Cotter Pin
Chute Crank
Eye Bolt
Hex
Nuts
Saddle
Washer
Figure 8
ASSEMBLING THE CHUTE
The snow thrower has been shipped with the upper chute pivoted all the way down. Assemble as follows:
Flat
No
Washer
Gap
Carriage
Bolt
Hand
Knob
Front
Upper
Chute
Figure 9
1.
2.
3.
Turn the chute crank until the chute facing straight to the front. See Figure 9.
Remove the hand knob, flat washer and carriage bolt from the upper chute.
Pivot the upper  chute up so  there is no  gap between the upper  and lower chute.  Secure with hardware  just
removed.
8
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 24 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website