MTD 230 240 250 260 261 S230 S240 S250 S260 S261 Snow Blower Owners Manual

6
Replacing Belt
WARNING: Before servicing,  repairing,
or inspecting, disengage the  control
bail and stop engine. Wait until all
moving parts have come to a complete
stop. Disconnect spark plug wire and
ground it against the engine to prevent
unintended starting.
Remove the belt cover by removing five hex screws. See
Figure 9. Then simply pull the belt off by grasping it from the
bottom of the auger pulley and pulling off.  Once you remove
the belt from the pulleys, you can push down on the idler
pulley to release the belt from under the belt keeper.
Idler Pulley
Adjustments
&
Maintenance
Belt Keeper
ToFigurereplace10: the  belt follow these instructions and refer to
To remove, pull belt off here
1.
2.
3.
4.
Push down on the Idler pulley.
Put belt on top of the auger pulley, under belt keeper.
Figure 
Thread belt around engine pulley.
WARNING
Before servicing,
Push belt over bottom of auger pulley.

Reinstall the belt cover removed earlier.

repairing, or inspecting,
disengage the control
bail and stop engine.
Wait until all moving
parts have come to a
complete stop. Discon-
nect spark plug wire
and ground it against
the engine to prevent
unintended starting.
Engine
1.
Refer to the separate engine manual for all engine
maintenance procedures.
2.
Check engine and snow thrower frequently for loose
hardware, and tighten as needed.

Lubrication
Lubricate pivot points on the control handle  and the
extension spring at the end of the control cable   with a
light oil once every season and before storage of the
snow thrower at the end of the season.

Replacing Auger Paddles
The snow thrower auger’s rubber paddles are subject to
wear and should be replaced if any signs of excessive
wear is present.
Figure 10
IMPORTANT: Do NOT allow the auger’s rubber paddles
to wear to the point where portions of the metal auger
itself can come in contact with the pavement. Doing  so
can result in serious damage to your snow thrower.
NofOAugerTE: FoKitr inreferformtoaticustomeron regardisupportng the ponricepageand 2.availability
IMPORTANT:
Do NOT allow the
auger’s rubber
paddles to wear
To change the rubber paddles, proceed as  follows:
to the point where
portions of the metal
auger itself can come
in contact with the
pavement. Doing so
can result in serious
damage to your snow
thrower.
1
.  Remove the existing rubber paddles by unscrewing the
self-tapping screws which secure them to the auger.
See Figure 11.
2.
Secure the replacement rubber paddles to the  auger
using the hardware removed earlier.
Figure 11
11
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags, , , , , , , , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 18 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website