MTD 2N1 2P5 Single Stage Snow Blower Owners Manual

7
Trouble-
Shooting
Problem
Engine fails to start
Cause
1.  Choke not in ON position.
Spark plug wire disconnected.
Fuel tank empty or stale fuel.
Engine not primed.
Remedy
1.  Move choke to ON position.
2.  Connect wire to spark plug.
3.  Fill tank with clean, fresh gasoline.
2.
3.
4.
4.  Prime engine as instructed  in
“Operating Your Snow Thrower”.
5.
6.
7.
Clean, adjust gap, or replace.
Clean fuel line.
5.
6.
7.
Faulty spark plug.
Blocked fuel line.
Safety key not in ignition on engine.
Fuel shut-off valve closed. (If
Insert key fully into the switch.
Open fuel shut-off valve.
8.
8.
Engine runs erratic
Engine overheats
1.  Unit running  on CHOKE.
1.  Move choke lever to OFF position.
2.  Cleanfresh gasoline.fuel line; fill tank with  clean,
3.  Drainfresh fuel.fuel tank. Refill with
2.  Blocked fuel line or stale fuel.
3.  Water or dirt in fuel system.
4.  Carburetor out of adjustment.
NOTE: This section
addresses minor
service issues. For
further details, contact
customer assistance.
4.  Contact Service  Center.
1.  Carburetor not adjusted properly.
Loose parts or damaged auger.
1.  Contact Service Center.
Excessive
Vibration
1.
1.  Stop engine  immediately and
disconnect spark plug wire. Tighten
all bolts and nuts. If vibration
continues, have unit serviced by a
Service Center.
Loss of power
1.  Spark plug wire  loose.
1.  Connectwire.       and tighten spark  plug
2
3
.  Gas cap vent hole plugged.
.  Exhaust port plugged.
2.  Remove ice and snow from gas
cap. Be certain vent hole is clear.
3.  Contact Service  Center.
toUnitpropelfails itself
1.  Dmreivnet.control  cable in need of adjust-
1.  Adjust“Adjustments”.drive control cable.  Refer to
2.  Replace drive belt.
2
.  Drive belt loose or damaged.
Unit fails
1
.  Chute assembly  clogged.
1.  Stop engine  immediately and
disconnect spark plug wire. Clean
chute assembly and inside of
auger housing with clean-out tool
or a stick.
2.  Stop engine immediately and
disconnect spark plug wire.
Remove object from auger.
3.  Refer to Maintenance section.
to discharge snow
2
3
.  Foreign object lodged  in auger.
.  Auger belt loose or damaged.
12
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags, , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 32 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

One thought on “MTD 2N1 2P5 Single Stage Snow Blower Owners Manual

  1. I would like to order a set of 2 Rubber Paddle (part #38) and a set of 4 Spiral-Crescent (part #39) for my Single-Stage Snow Thrower – Model 2N1. Is there a way to order those by Internet?

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website