MAINTENANCE AND REPAIR INSTRUCTIONS
LINE INSTALLATION
Indexing Teeth
This section covers both SplitLine™ and
standard single line installation.
Always use original equipment manufacturer
0.080
in. (2.03 mm) replacement line. Line
other than the specified may make the
engine overheat or fail.
Fig. 14
If necessary, remove burrs or replace
the reel and spool.
NOTE: SplitLine™ can only be used with
the inner reel with the slotted holes.
WARNING:
Never use
metal-reinforced line, wire, chain
or rope. These can break off and
become dangerous projectiles.
There are two methods to replace the
trimming line:
For Use with
For Use with Splitline™
or Single Line ONLY
Single Line ONLY
•
•
Wind the inner reel with new line
Install a prewound inner reel
Winding the Existing Inner Reel
1.
Hold the outer spool with one hand
and unscrew the Bump Knob™
counterclockwise (Fig. 12). Inspect
the bolt inside the Bump Knob to
make sure it moves freely. Replace
the Bump Knob if damaged.
Slotted
Holes
Fig. 15
Single line can be used on either
type of inner reel. Use Figure 15 to
identify the inner reel you have.
NOTE: Always use the correct line length
when installing trimming line on
the unit. The line may not release
properly if the line is too long.
Bolt
Bump Knob™
Single Line Installation
Go To Step 8 for SplitLine™ Installation
Fig. 12
6.
Take approximately 20 feet (6 m) of
new trimming line, loop it into two
equal lengths. Insert each end of the
2.
Remove the inner reel from the outer
spool (Fig. 13).
3.
4.
Remove spring from the inner reel (Fig. 13).
Use a clean cloth to clean the the
inner reel, spring, shaft, and inner
Outer Spool
Loop
Spring
Fig. 16
line through one of the two holes in
the inner reel (Fig. 16). Pull the line
through the inner reel so that the loop
is as small as possible.
Wind the lines in tight even layers,
onto the reel (Fig. 17). Wind the line
in the direction indicated on the inner
Inner Reel
Fig. 13
surface of the outer spool.
7.
5.
Check the indexing teeth on the inner
reel and outer spool for wear (Fig. 14).
12
| Categories | Bolens Trimmer Manuals, Lawn Mower Manual, MTD Lawn Mower Manuals, MTD Trimmer Manuals, Trimmer Manuals |
|---|---|
| Tags | Bolens BL100, Bolens BL150, MTD BL100, MTD BL150 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)