ASSEMBLY INSTRUCTIONS
INSTALL AND ADJUST THE D-HANDLE
have been started. Then tighten all screws
securely with a Phillips head screwdriver.
1.
Push the D-handle down onto the shaft
housing so that the handle slants towards
the shaft grip (Fig. 1). The squared bolt
hole in the handle is to the right.
Shaft Housing
2.
Insert the shoulder bolt into the squared
hole in the handle and push through.
On the left side of the handle, place the
washer on the bolt, then screw the wing
nut onto the bolt. Do not tighten until
you make the handle adjustment.
Rotate the D-handle to place the grip
above the top of the shaft housing. Place
it a minimum of 6 inches (15.24 cm) from
the end of the shaft grip.
Cutting
Attachment
Shield
Shield
Mount
Cutting
Attachment
Fig. 2
3.
Nuts (3)
Recessed
Holes
Shaft Grip
Hex Lock
Nut
Shaft Housing
D-Handle
Tighten
Screws (3)
Fig. 3
Install on a Curved Shaft (BL100)
Minimum 6 inches
Wing
Nut
Washer
1.
Place the cutting attachment shield
onto the shaft housing. Be sure the
guard mounting bracket slides into
the slot on the edge of the cutting
shield. Rotate the shield into place,
counterclockwise (Fig. 4). The holes
in the guard mounting bracket and
cutting attachment shield will line up.
(15.24 cm)
Bolt
Fig. 1
4.
5.
While holding the unit in the operating
position (Fig. 2), position the D-handle
to the location that provides you the
best grip.
Tighten the wing nut until the D-handle
is secure.
Guard
Mounting
Bracket
INSTALLING THE CUTTING SHIELD
Use the following instructions if the cutting
attachment shield on your unit is not
installed or if you ever need to re-install it.
Cutting Attachment Shield
Fig. 4
Install on a Straight Shaft (BL150)
Guard
Mounting
Bracket
Washer
1.
Slide the cutting attachment shield
into the shield mount on the cutting
attachment. Align the screw holes in
the shield with the holes in the cutting
attachment shield mount (Fig. 2).
Wing Nut
2.
3.
4.
Place one of the three (3) supplied
hex lock nuts into one of the three
recessed holes on the top of the
cutting attachment shield (Fig 3).
Install a screw into the hole from the
bottom of the cutting attachment shield.
Screw it into the nut installed in step 2
until it is started (Fig 3). Do not tighten.
Square Bolt
Fig. 5
2.
3.
From inside the cutting attachment shield,
push the square bolt through the hole
until the threaded end protrudes through
the guard mounting bracket (Fig. 5).
Put the washer on the bolt, then screw
the wing nut onto the bolt and tighten.
Repeat steps 2 and 3 until all three screws
7
| Categories | Bolens Trimmer Manuals, Lawn Mower Manual, MTD Lawn Mower Manuals, MTD Trimmer Manuals, Trimmer Manuals |
|---|---|
| Tags | Bolens BL100, Bolens BL150, MTD BL100, MTD BL150 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)