•
•
•
•
Drain the gasoline from the snow thrower, or place
a piece of plastic film under the gas cap.
Tip the snow thrower up and forward so that it rests
on its auger housing.
Remove the six self-tapping screws from the frame
cover underneath the snow thrower.
•
Replace both auger drive belts by following
instructions in reverse order.
NOTE: If you placed plastic film under the gas cap, be
certain to remove it before operating the snow thrower.
Drive Belt
Roll the front and rear auger belts off the auger
drive pulley. See Figure 14.
•
•
•
•
Follow the first four steps of the instructions for
servicing the auger belts.
Pull the idler pulley up and lift the belt off the wheel
drive pulley and friction wheel disc. See Figure 14.
Back out the stop bolt until the support bracket
rests on the auger pulley. See Figure 15.
Slip the belt between the friction wheel and drive
disc. Remove and replace the belt. Reassemble
following the instructions in reverse order.
Drive
Pulley
Auger
Pulley
Drive
Belt
NOTE: The support bracket must rest on the stop bolt
after the new belt has been assembled.
Idler
Pulley
Idler
Pulley
Auger
Belts
Friction
Wheel
Drive Plate
Frame
Stop Bolt
Frame
Support
Bracket
Support Bracket
Auger Pulley
Figure 15
Rear
Auger
Belt
Replacing Friction Wheel Rubber
Support
Bracket
Spring
The rubber on the friction wheel is subject to wear and
should be checked after 25 hours of operation, and
periodically thereafter. Replace the friction wheel
rubber if any signs of wear or cracking are found.
Front
Auger Belt
Auger Housing
Idler Spring
•
•
•
•
•
Drain the gasoline from the snow thrower, or place
a piece of plastic under the gas cap.
Tip the snow thrower up and forward, so that it rests
on the housing.
Remove the six self-tapping screws from the frame
cover underneath the snow thrower.
Remove the click pin that secures the left wheel to
the axle and slide the wheel from the axle.
Remove the four screws securing the left drive
cover to the frame. Remove the drive cover. See
Figure 16.
Figure 14
•
•
Unhook the idler spring from the hex bolt on the
auger housing. See Figure 14.
Back out the stop bolt until the support bracket
rests on the auger pulley.
NOTE: Loosening the six nuts that connect the frame to
the auger housing may aid in belt removal.
•
Lift the rear auger belt from the auger pulley, and
slip the belt between the support bracket and the
auger pulley. Repeat this step for the front auger
belt.
13
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, White Outdoor Snow Blower Manuals |
|---|---|
| Tags | MTD 1150W, MTD 850W, MTD Snow Blower Manual, White Outdoor Snow Boss 1150W, White Outdoor Snow Boss 850W |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(1 votes, average: 2 out of 2)
Lawn and Garden readers have rated MTD White Outdoor Snow Boss 850W 1150W Snow Blower Owners Manual 2.0 out of 2.0 based on 1 product reviews. I am trying to get information on the engine and this manual does not possess tyhat info and I can find no place on the web site that lists an engine manual.