SECTION2: ASSEMBLINGYOURSNOWTHROWER
NOTE: Any reference in this manual to the left or right
side of the snow thrower is observed from the
operator’s position.
•
•
Raise the upper handle assembly until it locks over
the lower handle.
Look at the lower rear of the snow thrower frame to
be sure all the cables are aligned with the cable
roller guides.
Unpacking
•
Secure the upper handle and lower handle with the
two plastic wing nuts, cupped washers and carriage
bolts previously removed and tighten the upper two
plastic wing nuts. See Figure 3.
•
Remove screws from the top sides and ends of the
shipping crate.
Set panel aside to avoid tire punctures or personal
injury.
•
•
•
Remove and discard plastic bag that covers unit.
Remove any loose parts included with unit (i.e.,
Operator’s Manual, etc).
Upper
Shift Rod
•
Roll unit out of crate.
Shift Rod
Connector
Loose Parts
Lower
Shift Rod
The augers are secured to the auger shaft with two
shear bolts and hex lock nuts. If you hit a foreign object
or ice jam, the snow thrower is designed so that the
bolts may shear. Two replacement shear bolts and nuts
are provided for your convenience. Store in a safe
place until needed. See Figure 1.
Wing Nuts
Figure 3
Shear Bolts
Hex Lock
Nuts
•
Slide the shift rod connector down over the end of
the lower shift rod. Tap the connector until it locks
over the lower shift rod. See Figure 3.
NOTE: If the connector is not properly assembled, the
shift rod will pivot and you will not be able to change
speeds or change directions.
Figure 1
Assembly
•
If not already attached, slip the cables that run from
the handle panel to the chute into the cable guide
located on top of the engine. See Figure 4.
WARNING: Disconnect the spark plug
wire and ground it against the engine to
prevent unintended starting.
Cable Guide
•
Remove the lower two plastic wing nuts, cupped
washers and carriage bolts from each side of the
lower handle. See Figure 2.
Lower
Handle
Handle
Panel
Figure 4
•
•
•
Unwrap the headlight wire, which is attached to the
headlight beneath the handle panel.
Wind the headlight wire around the right handle
until excess slack is removed.
Plug the wire from the headlight into the wire lead
coming from the right side of the engine, beneath
the fuel tank.
Upper Handle
Wing Nuts,
Washers, & Bolts
Figure 2
5
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, White Outdoor Snow Blower Manuals |
|---|---|
| Tags | MTD 1150W, MTD 850W, MTD Snow Blower Manual, White Outdoor Snow Boss 1150W, White Outdoor Snow Boss 850W |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(1 votes, average: 2 out of 2)
Lawn and Garden readers have rated MTD White Outdoor Snow Boss 850W 1150W Snow Blower Owners Manual 2.0 out of 2.0 based on 1 product reviews. I am trying to get information on the engine and this manual does not possess tyhat info and I can find no place on the web site that lists an engine manual.