ENGLISH
1.
2.
With the engine running, quickly pull the re-
coil starter handle (12) three or four times
with a continuous full arm stroke. This will
produce a loud clattering sound that is not
harmful to the engine or starter.
Stop the engine. Wipe all snow and moisture
from the carburetor cover, control levers and
cables. Also move the throttle control (13),
choke control (14), and recoil starter han-
dle (12) several times.
3. Remove (do not turn) the ignition key (8).
4. Whenever possible, discharge the snow
down wind.
4.
5.
Disconnect the spark plug wire.
5. For normal usage, set the skids so that the
scraper bar is 1/8” above the skids. For ex-
tremely hard-packed snow surfaces, adjust
the skids upward so that the scraper bar
touches the ground.
6. Rocks and gravel must not be picked up and
thrown by the machine. On gravel or crushed
rock surfaces, set the skids at 1-1/4 inch be-
low the scraper bar. See “How To Adjust The
Height Of The Skids” in the Maintenance
section.
Do not place your hands in the auger hous-
ing (4) or the discharge chute (3). Use a
pry bar to remove any snow or debris.
Snow Throwing Tips
1. For maximum snow thrower efficiency,
change the ground speed, NEVER change
the engine speed. The engine is designed to
deliver maximum performance at full throttle
and must be run in the fast position at all
times. In deep, freezing, or wet snow, reduce
forward speed. If the wheels slip, also reduce
forward speed.
How To Remove Snow or Debris From
The Auger Housing (Figure 2)
7. After each snow throwing job, allow the en-
gine to idle for a few minutes. The snow and
accumulated ice will melt off the engine.
8. Clean the snow thrower after each use.
WARNING: Do not attempt to re-
move snow or debris that may be-
come lodged in auger housing
2.
Most efficient snow throwing is accomplished
when the snow is removed immediately after
if falls.
without taking the following precautions.
9.
Remove ice, snow and debris from the entire
snow thrower. Flush with water to remove all
salt or other chemicals. Wipe snow thrower
dry.
1.
2.
Release the auger drive lever (5).
Move the throttle control (13) to the stop
position.
3. For complete snow removal, slightly overlap
each previous path.
F-031012L
14
| Categories | Murray Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Murray 627808X5A |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 4 out of 4)
Lawn and Garden readers have rated Murray 627808X5A Snow Blower Owners Manual 4.0 out of 4.0 based on 1 product reviews. thanks a whole bunch with being who you are. I hope someday to be just like you. Have a great day