Operation
ENGINE SPEED
Throttle
Lever
For overall best performance, run the snowthrower at full
engine operating speed. Use the engine Throttle Lever
(See Figure 8) to set the engine speed. Slide the Throttle
Lever UP to increase engine speed, and DOWN to
reduce speed.
GROUND SPEED SELECTOR
Use the Speed Selector (A, Figure 7) to control the drive
speed of the snowthrower. There are five forward speeds
and two reverse speeds.
Use the lower speeds to blow deep or wet snow. Use the
higher speeds to blow light snow or to drive the snow-
thrower without blowing snow.
Figure 8. Engine Speed Selection
To change speeds, first release the traction Drive Control
lever (B, Figure 7), then move the Speed Selector to the
desired speed setting. Fully press the traction Drive
Control lever to resume operation.
Chute
Deflector Knob
DEFLECTOR
The distance of the discharged snow is mainly controlled
by the position of the deflector (Figure 9). (Engine speed
also affects distance of discharge.)
The more the deflector is tilted UP, the farther snow will
be thrown. Loosen the deflector knob, tilt the deflector
UP or DOWN, and then retighten the knob when the
desired angle has been chosen.
Chute
Deflector
SCRAPER BAR & SKID SHOES
On smooth surfaces such as concrete or asphalt, the
scraper bar should scrape the surface. On surfaces such
as gravel, the scraper bar should be high enough so that
it will not pick up gravel or debris.
Figure 9. Chute Deflector Adjustment
The height of the scraper bar is controlled by raising or
lowering the Skid Shoes (See Figure 10).
1.
To raise the scraper bar height, rest the scraper bar
on a strip of wood equal in thickness to the desired
height.
2.
3.
4.
5.
6.
Make sure the scraper bar is parallel to the ground
surface.
Loosen the skid shoe nuts and let the skid shoes
drop to the surface.
Scraper
Bar
Tighten the nuts, making sure the Skid Shoes are
adjusted equally and are parallel to the surface.
Skid Shoe
Nuts
To lower the height of the scraper bar, raise the Skid
Shoes.
Skid Shoe
Figure 10. Skid Shoe Adjustment
If the scraper bar becomes worn, it can be replaced
by removing the hardware attaching it to the
snowthrower.
10
| Categories | Simplicity Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Simplicity 1693161, Simplicity 1693162, Simplicity 1693163, Simplicity 1693164, Simplicity 1693425, Simplicity 1693426, Simplicity 555, Simplicity 755 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Simplicity, Snow Blower |
| Document File Type | |
| Publisher | simplicitymfg.com |
| Wikipedia's Page | Simplicity Outdoor |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)