Simplicity 555 755 1693161 1693163 1693425 1693162 1693164 1693426 Series Snow Blower Owners Manual

Service
ROLLER CHAIN REPLACEMENT
1.
2.
3.
Remove gas from fuel tank and run engine until it
stops running from lack of fuel.
Keeper link
(Must install towards wheel side
with open end trailing.)
Disconnect spark plug wire and fasten it away from
the spark plug.
Tilt the snowthrower forward and carefully rest unit
on the auger end.
Master link
4.
5.
6.
Rotate the wheel to locate the roller chain master link.
Remove the keeper link, master link and chain.
Install new chain and keeper link as shown in Figure
25.
7.
8.
Return snowthrower to upright operating position.
Connect spark plug wire and fill fuel tank.
Direction of travel
Figure 25.   Roller Chain Master Link
SHEAR PIN REPLACEMENT
Under most circumstances, if the auger strikes an object
which could cause damage to the unit, the shear pin will
break. (This protects the gear box and other parts from
damage.)
The shear pins are located on the auger shaft as shown
in Figure 26. To replace the shear pins, tap out broken
pin with a pin punch, and install a new shear pin and cot-
ter pin. Spread the legs of the new cotter pin fully. Do
NOT replace shear pins with anything other than the
correct grade replacement shear pin. See the
REPLACEMENT PARTS section at the back of this man-
ual for the correct part numbers.  (Use of bolts, screws or
a harder shear pin will lead to damaged equipment.)
Shear
Pins
WARNING
Figure 26.  Shear Pin Replacement
Do not go near  the discharge chute or auger when  the
engine  is  running.  Do  not  run  the  engine  with  any
cover or guard removed.
AUGER SHAFT BEARING
REPLACEMENT
If auger shaft bearings need replacement, proceed as
follows:
Washer(s)
1.
2.
Pry off the E-ring (Figure 27).
Remove the washers, then pull the bearing out of the
housing and off the shaft.
E-ring
3.
4.
5.
Apply a coating of grease to inside diameter of bear-
ings.
Bearing
Install new bearing by aligning bearing flat sides with
flat sides in housing.
Figure 27.  Auger Bearings
Install washers. Install a new E-ring securely in shaft
21
Product Specification
CategoriesSimplicity Snow Blower Manuals, Snow Blower Manuals
Tags, , , , , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandSimplicity, Snow Blower
Document File TypePDF
Publishersimplicitymfg.com
Wikipedia's PageSimplicity Outdoor
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website