Simplicity 555 755 1693161 1693163 1693425 1693162 1693164 1693426 Series Snow Blower Owners Manual

Service
AUGER DRIVE CLUTCH ROD
ADJUSTMENT
The auger drive clutch rod should be adjusted so that
there is no slack in the rod when moved slightly from
side to side. To adjust tension on the rod:
Auger Drive
Clutch Rod
1.
2.
Loosen adjustment hex nuts (Figure 19).
Tighten top hex nut while holding rod. Tighten just
until slack in rod is removed. Be careful not to move
idler rod lever when adjusting clutch rod tension.
CAUTION
Adjustment
Hex Nuts
Do not over-tighten,  as this may lift  the idler rod lever
and  cause   auger    drive   to  be  engaged    without
depressing the Auger Control.
3.
Tighten lower hex nut securely.
Auger Drive
4.  Start unit and check auger. Auger must not be
Clutch Rod Spring
engaged unless Auger Control is depressed.
5.
6.
7.
8.
With engine running, fully depress Auger Control, the
auger should engage and run normally.
Idler Rod
Right Handle
Release Auger Control. Auger must stop within 5
seconds.
Figure 19.  Auger Drive Clutch Rod Adjustment
If auger does not operate properly, stop engine and
recheck clutch rod adjustments.
If clutch rod is properly adjusted, auger drive belt ten-
sion may require adjustment. See "Adjusting Auger
Drive Belt" on next page.
DRIVE BELT ADJUSTMENT
The snowthrower is equipped with two drive belts locat-
ed just in front of the engine under the belt cover. Figure
Engine Pulley
20
shows both belts and idler pulleys. The belt nearest
the engine is the unit traction drive (wheels) belt. The
belt farthest from the engine is the auger/ impeller drive
belt.
Engine Pulley
Idler Pulley
Idler Pulley
DRIVE
BELT
The traction drive belt has constant tension provided by
a spring-loaded idler pulley arm, and is non-adjustable.
This belt rotates whenever the engine is running, and
provides power to the traction drive disc, which also
rotates constantly while the engine is running.
Traction
Drive Pulley
AUGER
BELT
Auger Pulley
The auger drive belt tension may be adjusted by moving
the auger drive idler pulley. See "Adjusting Auger Drive
Belt’ on next page.
FRONT
(Auger)
Figure 20.  Drive Belt Paths
17
01
Product Specification
CategoriesSimplicity Snow Blower Manuals, Snow Blower Manuals
Tags, , , , , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandSimplicity, Snow Blower
Document File TypePDF
Publishersimplicitymfg.com
Wikipedia's PageSimplicity Outdoor
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website