Operation
STARTING THE ENGINE
1.
2.
3.
Check the oil level. See the Engine Manual How
to Check/Add Oil section
Make sure equipment drive controls are
disengaged.
Push the stop switch to the on position (A, Figure
3).
A
Figure 5. Rewind Start
A. Starter Cord Handle
A
Note: If the engine does not start after three attempts,
see the Engine Manual Troubleshooting section.
Figure 3. On/Stop Switch
A. On/Stop Switch Selector
8.
Electric Start: First connect the extension cord to
the power cord receptacle and then into a wall
receptacle. If additional extension cord is
required, make sure it is 3-wire.
4.
Insert the engine key (A, Figure 4) into the engine
key slot and push fully in to the RUN position.
5.
Turn the choke knob (B) fully clockwise if engine is
cold.
WARNING
Note: Do not use the choke to start a warm engine.
6.
Push the primer button (C) two times.
If the extension cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person to avoid to
avoid a hazard.
Note: Do not use the primer to start a warm engine.
9
. Electric Start: Depress the push button (A, Figure
6). After you start the engine, first disconnect the
C
extension cord from the wall receptacle and then
from the power cord receptacle (B).
B
A
A
Figure 4. Safety Key, Choke, and Primer Button
A. Safety Key
B
B. Choke Control Knob
C. Primer Button
Figure 6. Electric Start
A. Starter Push Button
B. Power Cord Receptacle
7.
Rewind Start: Firmly hold the starter cord handle
(A, Figure 5). Pull the starter cord handle slowly
until resistance is felt, then pull rapidly.
CAUTION
WARNING
To extend the life of the starter, use short
starting cycles (five seconds maximum.) Wait
one minute between starting cycles.
Rapid retraction of the starter cord (kickback)
will pull your hand and arm toward the engine
faster than you can let go. Broken bones,
fractures, bruises or sprains could result.
When starting engine, pull the starter cord
slowly until resistance is felt and then pull
rapidly to avoid kickback.
Note: If the engine does not start after three attempts,
see the Engine Manual Troubleshooting section.
16
| Categories | Simplicity Snow Blower Manuals, Snapper Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Simplicity 1695302, Simplicity 1695311, Simplicity 1695313, Simplicity 1695314, Simplicity 1695410, Simplicity 1695411, Snapper 1695302, Snapper 1695311, Snapper 1695313, Snapper 1695314, Snapper 1695410, Snapper 1695411 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Simplicity, Snow Blower |
| Document File Type | |
| Publisher | simplicitymfg.com |
| Wikipedia's Page | Simplicity Outdoor |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)