Simplicity Snapper 1695302 1695311 1695410 1695313 1695314 1695411 Intermediate Frame Snow Blower Owners Manual

Adjustments
Run-In Adjustment
8.  Note the position of the friction wheel (A, Figure
24).
The correct distance from the right side of the
ALL MODELS
friction wheel to the outside of the frame is 4-5/16”
(10.95 cm).  If the friction wheel is not in the
correct position, adjust as follows.
1.
After 5 hours of use, check for proper adjustment.
Readjust clutch cable if necessary by increasing
tension on cable. A small amount of arm
9.
Move the friction wheel (A, Figure 24) to the
correct distance, 4-5/16” (10.95 cm).
movement is permissible if unit passes operating
checks described in the Warning above.
10.
11.
12.
Tighten the 1/4-20 shift lever nuts (B, Figure 23) to
60 lb-in. (6,8 Nm).
WARNING
Check that the snowthrower operates in R1. If not
follow procedures 1-10 and readjust as necessary.
Gasoline is highly flammable and must be
handled with care. Drain gasoline outdoors.
Never drain the tank when the engine is still
hot from recent operation. Do not allow open
flame, smoking or matches in the area. Avoid
over-filling and wipe up any spills.
Install the bottom panel (B, Figure 22) and tighten
the capscrews (A).
2.
Remove the gas from the gas tank.
Disconnect the spark plug wire.
3.
4.
Stand snowthrower on the front of the auger
housing (C, Figure 22).
A
B
5.
6.
Remove the capscrews (A) on each side of the
bottom panel (B).
Remove the bottom panel (B).
4-5/16”
(10.95
cm)
Figure 24. Friction Disc Measurement
A.  Friction Wheel
B.  Frame
A
A
C
ADJUST THE DRAG ON THE CHUTE
ROTATION
Note: After repeated use, the chute rotation gear may
loosen, causing the chute to move back to the center
position.
B
Figure 22. Bottom Cover
A.  Capscrews
Adjust the drag by tightening the nut (A, Figure 25).
Tightening the nut will limit the chute from moving without
the operator turning the chute rotation crank.
B.  Bottom Panel
C.  Auger Housing
7.
Loosen shift lever screws (A, Figure 23), and
position the shift speed lever in the lowest forward
speed.
A
A
B
Figure 25. Chute Rotation Gear
A.  Nut
Figure 23. Shift Lever Adjustment
A.  Shift Lever
B.  Nuts, 1/4-20
27
Product Specification
CategoriesSimplicity Snow Blower Manuals, Snapper Snow Blower Manuals, Snow Blower Manuals
Tags, , , , , , , , , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 38 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandSimplicity, Snow Blower
Document File TypePDF
Publishersimplicitymfg.com
Wikipedia's PageSimplicity Outdoor
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website