Service
9.
Remove hair pin (A, Figure 33) and slide rod (B)
backward about 3 inches (until shaft separates
from the worm drive).
11.Lift the chute and rotator (A, Figure 35) off of the
auger housing.
B
A
A
Figure 33. Rotator Shaft Removal
A. Pin, Hair
B. Shaft
10.
Remove two 5/16-18 KEPS hex nuts (A, Figure
34), and two 5/16-18 x 1-1/2 carriage bolts (B)
securing the offset tube (C) to the tube support
bracket (D).
A
Figure 35. Chute and Rotator Removal
A. Chute and Rotator
12.
Remove the upper four capscrews (A, Figure 36)
that hold together the auger housing (C) and the
frame (D). Loosen the lower two capscrews (B).
The auger housing (C) and the frame (D) can now
be split apart for removal of the belt.
C
B
D
A
B
Figure 34. Offset Tube (Lower) Removal
A. Nuts, KEPS, hex, 5/16-18
B. Bolts, Carriage, 5/16 x 1-1/2
C. Tube, Offset
D. Bracket, tube support
D
C
Figure 36. Frame and Axle Housing Splitting
A. Upper Capscrews
B. Lower Capscrews
C. Auger Housing
D. Frame
13.
Remove the old auger drive belt (D, Figure 31)
from the impeller pulley. Replace the auger drive
belt with an original factory replacement belt
available from an authorized service center.
14.
Install the new auger drive belt (D) onto the
impeller pulley.
31
Categories | Simplicity Snow Blower Manuals, Snapper Snow Blower Manuals, Snow Blower Manuals |
---|---|
Tags | Simplicity 1695302, Simplicity 1695311, Simplicity 1695313, Simplicity 1695314, Simplicity 1695410, Simplicity 1695411, Snapper 1695302, Snapper 1695311, Snapper 1695313, Snapper 1695314, Snapper 1695410, Snapper 1695411 |
Download File |
|
Document Type | Owner's Manual |
Language | English |
Product Brand | Simplicity, Snow Blower |
Document File Type | |
Publisher | simplicitymfg.com |
Wikipedia's Page | Simplicity Outdoor |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)