English / USA
Removing the Mowing Head
:
Block the output shaft.
STIHL SuperCut 20-2,
STIHL AutoCut 25-2,
STIHL AutoCut C 25-2,
STIHL TrimCut 30-2,
STIHL PolyCut 20-3
1
:
Unscrew the mowing head
clockwise.
STIHL FixCut 25-2
:
Use the combination wrench to
unscrew the mountingnut clockwise
from the output shaft
If the mounting nut is too loose, fit a
new one
Mounting the Mowing Head
STIHL FixCut 25-2
Keep instruction sheet for mowing head
in a safe place.
:
Place the mowing head on the
thrust plate (2).
Adjusting Nylon Line
STIHL SuperCut
Collar (arrows) must locate in the
mowing head’s mounting hole
:
Screw the
STIHL SuperCut 20-2,
STIHL AutoCut 25-2,
STIHL AutoCut C 25-2,
STIHL TrimCut 30-2,
STIHL PolyCut 20-3
counterclockwise onto the shaft (1)
as far as stop.
Fresh line is advanced automatically if
remaining line is still min. 2 1/2" (6 cm)
long. The blade on the deflector trims
overlong line to the correct length.
:
Push the thrust washer (3) over the
shaft (1) so that it locates against
the base.
:
:
Block the output shaft.
Screw the mounting nut (4) with the
combination wrench (5)
counterclockwise on to the output
shaft and tighten down firmly.
:
:
Block the output shaft.
Tighten down the mowing head.
Remove the tool used to block the
shaft.
Remove the tool used to block the
shaft.
20
FS-KM
| Categories | Hedge Trimmer Manuals, STIHL Hedge Trimmer Manuals, Trimmer Manuals |
|---|---|
| Tags | STIHL FS, STIHL KM |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Trimmer |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)