English / USA
Fitting the Harness
:
:
Place the cutting tool (6) on the
thrust plate (7).
Collar (see arrows) must locate in
cutting tool’s mounting hole.
Slip thrust washer (8) and rider
plate (9) over the output shaft (10).
:
:
Block the output shaft and
Screw the mounting nut (11) with
the combination wrench (12) onto
the output shaft counterclockwise
and tighten down firmly.
If the mounting nut is too loose,
fit a new one.
Removing cutting tool
:
:
:
Block the output shaft.
Unscrew the nut clockwise.
The type and style of harness depend on
the market.
Full harness
Removing the cutting tool – do not
remove the thrust plate (7).
:
:
Put on the full harness (1).
Adjust length until the spring hook
2) is about a hand’s width below
Shoulder strap*
(
:
:
Put on the shoulder strap (1).
your right hip.
Adjust length until the spring hook
:
Balance the brushcutter.
(
2) is about a hand’s width below
your right hip.
The use of the harness is described in
chapter “Approved Combinations of
Cutting Tool, Deflector, Handle and
Harness”.
:
Balance the brushcutter.
The use of the shoulder strap is
described in chapter “Approved
Combinations of Cutting Tool, Deflector,
Handle and Harness”.
22
FS-KM
| Categories | Hedge Trimmer Manuals, STIHL Hedge Trimmer Manuals, Trimmer Manuals |
|---|---|
| Tags | STIHL FS, STIHL KM |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Trimmer |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)