English / USA
Taking Care of Guide Bar
After long period of full-throttle
operation
Chain
type
Pitch
Minimum
groove
depth
Allow engine to run for a short while at
idle speed so that engine heat can be
dissipated by flow of cooling air. This
protects engine-mounted components
(ignition, carburetor) from thermal
overload.
2
Picco
Rapid
Rapid
Rapid
3/8“ P
0.20"
(5.0
mm)
1/4“
0.16"
(4.0
mm)
3/8“; 0.325“
0.404“
0.24"
(6.0
mm)
After finishing work
3
0.28"
:
Slacken off the chain if you have
retensioned it at operating
(7.0 mm)
temperature during cutting work.
If groove depth is less than specified:
Replace the guide bar.
The chain contracts as it cools
down. If it is not slackened off, it
could damage the crankshaft and
bearings.
:
The drive link tangs will otherwise
scrape along the bottom of the groove –
the cutters and tie straps will not ride on
the bar rails.
1
3
Storing your saw for a short period:
Wait for engine to cool down. To avoid
condensation, fill the fuel tank and keep
the machine in a dry place, well away
from sources of ignition, until you need it
again.
:
Turn the bar over –
every time you sharpen the chain
and every time you replace the
chain – this helps avoid one-sided
wear, especially at the nose and
underside of the bar.
Storing for a long period:
See “Storing the Machine”!
:
:
Regularly clean
the oil inlet hole (1),
the oilway (2) and
the bar groove (3).
Measure groove depth –
with scale on filing gauge* – in area
used most for cutting.
*
see “Guide to Using this Manual”
34
MS 192 T, MS 192 TC
| Categories | Chainsaw Manuals, STIHL Chainsaw Manuals |
|---|---|
| Tags | STIHL MS 192 |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Chainsaw |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)