english / USA
Oil Quantity
Taking Care of Guide Bar
Control
Chain
type
Pitch
Minimum
groove
depth
2
Picco
Rapid
Rapid
Rapid
3/8“ P
0.20"
(5.0 mm)
0.16"
(4.0 mm)
1
1/4“
3/8“; 0.325“
0.404“
0.24"
(6.0
mm)
3
Different quantities of oil are required for
different bar lengths, types of wood and
cutting techniques.
0.28"
(7.0 mm)
:
Use the adjusting screw (1) (on
underside of machine) to vary the
oil feed rate as required.
For average oil feed rate, turn
adjusting screw to “E“ (Ematic
position).
If groove depth is less than specified:
Replace the guide bar.
The drive link tangs will otherwise
scrape along the bottom of the groove –
the cutters and tie straps will not ride on
the bar rails.
:
1
:
3
:
:
To increase oil feed – turn adjusting
:
Turn the bar over –
screw clockwise.
every time you sharpen the chain
and every time you replace the
chain – this helps avoid one-sided
wear, especially at the nose and
underside of the bar.
To reduce oil feed – turn adjusting
screw counter-clockwise.
Your chain must always be wetted
with a film of lubricant.
:
:
Regularly clean
the oil inlet hole (1),
the oilway (2) and
the bar groove (3).
Measure groove depth –
with scale on filing gauge* – in area
used most for cutting.
*
see “Guide to Using this Manual”
42
MS 360 C
| Categories | Chainsaw Manuals, STIHL Chainsaw Manuals |
|---|---|
| Tags | STIHL MS 360 |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Chainsaw |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)