SECTION 9: MAINTENANCE
WARNING: Disconnect
the
spark
BELT REMOVAL AND REPLACEMENT
plug
engine before performing any repairs
or maintenance.
wire and ground against the
WARNING: Remove the spark plug
wire from the spark plug and ground.
Drain gasoline from the fuel tank, or
place a piece of plastic film underneath
the gas cap to prevent gasoline from
leaking.
AUGERS
The augers are secured to the spiral shaft with two
shear bolts and hex lock nuts. See Figure 15. If you
hit a foreign object or ice jam, the snow thrower is
designed so that the shear bolts will shear.
If the augers will not turn, check to see if the hex
bolts have sheared. Two replacement shear bolts
and hex lock nuts have been provided with the
snow thrower. When replacing bolts, spray an oil
lubricant into shaft before inserting new bolts.
Auger Drive Belt
To remove and replace either the auger drive belt or
the drive belt, proceed with the following instructions:
1. Disconnect
chute
crank
assembly
at
the
discharge chute by removing the cotter pin and
flat washer.
2.
Remove the plastic belt cover on the front of the
engine by removing three self-tapping screws
and flat washers. See Figure 16.
Auger Shear Bolts
Belt
Cover
Self-Tapping
Screw
Flat Washer
Auger Shaft
Shave Plate
Hex Lock Nuts
Figure 15
SHAVE PLATE AND SKID SHOES
The shave plate and skid shoes on the bottom of
the snow thrower are subject to wear. They should
Figure 16
3.
Remove the large shoulder bolt and washer on
the left hand side of the engine pulley with an
adjustable wrench. Refer to Figure 17.
be
checked
periodically
and
replaced
when
necessary.
NOTE: All models are equipped with reversible
skid shoes.
NOTE: Reference to right hand or left hand side of
machine are observed from the operating position.
To remove skid shoes, remove the carriage bolts,
Belleville washers and hex nuts which attach them
to the snow thrower. Reassemble new skid shoes
with the carriage bolts, Belleville washers (cupped
side goes against skid shoes) and hex nuts.
4.
Remove the cotter pin and washer from the
ferrule in order to disconnect the auger idler rod
from the brake bracket assembly as shown in
Figure 18.
5.
6.
Slip the auger drive belt (the front belt) off the
engine pulley. Refer to Figure 18.
To remove shave plate, remove the carriage bolts,
Belleville washers and hex nuts which attach it to
the snow thrower housing. Reassemble new shave
plate, making sure heads of the carriage bolts are to
the inside of the housing. Tighten securely.
Pull the brake bracket assembly towards the
cable guide roller and unhook the auger cable
“Z” fitting.
7.
Remove the top screws and lock washers which
attach the auger housing assembly to the frame
assembly. A 9/16” wrench is required. Refer to
Figure 19.
11
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, Yard Machines Snow Blower Manuals |
|---|---|
| Tags | MTD 800, MTD Snow Blower Manual, Yard Machines 800 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Yard Machines, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)