•
Reassemble pulley to auger housing with hex
Engine
Pulley
screw
and belleville washer (cupped is
toward the pulley). Be certain key is in place
on shaft and brake puck is seated in the
pulley groove.
Large
Shoulder
Bolt
Brake
Bracket
Assembly
Extension
Spring
Auger Drive
Belt
Figure 17
Pulley
Auger
Idler
Rod
Ferrule
Belt
Brake
Bracket
Keepers
Hex Screw
Belleville Washer
Assembly
Cable
Roller
Guide
Figure 20
Proper Adjustment With the auger clutch lever in
the disengaged position the top surface of the new
belt should be even with the outside diameter of the
pulley. To adjust, disconnect ferrule from the brake
bracket assembly and thread ferrule in (towards
idler) to increase tension on belt, out to decrease
tension. (See Figure 18.)
“Z”
Fitting
Figure 18
Auger
Housing
NOTE: The brake puck must always be firmly
seated in the pulley groove when the auger clutch
lever is in the disengaged position.
Remove
Screw
Lock Washer
Frame Assembly
To Remove the Drive Belt
•
•
•
Unhook extension spring from the belt cover
plate. See Figure 17.
Remove drive belt from the engine pulley and
bottom drive pulley.
Replace belt and reassemble in reverse order.
Figure 19
9.
Reassemble the two halves of the unit hooking
the lower portion of the auger housing over the
stationary shoulder bolts in the frame assembly.
8.
Separate the auger housing from the frame
assembly by tilting the housing forward and
pulling up the handles.
To Remove the Auger Drive Belt
10. Secure the two halves with the two screws and
lock washers
•
Using a 1/2” wrench remove the hex screw
and belleville washer from the center of the
pulley on the auger housing. Lift the brake
bracket assembly out of the pulley groove
and remove the pulley. See Figure 20. Be
careful not to lose the key.
11. Attach the “Z” fitting of the cable into the brake
bracket assembly. See Figure 18.
12.
13.
Slip the auger drive belt over engine pulley.
Insert ferrule on auger idler rod into bracket
bracket assembly and secure with flat washer
and cotter pin.
•
Remove and replace auger drive belt inside
belt keepers.
14.
Reassemble the large shoulder bolt and lock
washer as shown in Figure 17.
15.
16.
Reassemble belt cover and chute crank.
Remove plastic film from gas cap.
12
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, Yard Machines Snow Blower Manuals |
|---|---|
| Tags | MTD 800, MTD Snow Blower Manual, Yard Machines 800 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Yard Machines, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)