Husqvarna 323P4 325P5 X-Series Chainsaw Owners Manual

ASSEMBLY
Fitting the cutting head
The chain is correctly tensioned when there is no slack on
the underside of the bar, and it can still be turned easily by
hand. Tighten the bar nut with the combination spanner
while holding up the tip of the bar.
Fit the cutting head on the shaft so that the screw (A) is
aligned with the hole in the shaft as shown.
Tighten screw A.
Tighten screw B.
B
When fitting a new chain, the chain tension has to be
checked frequently until the chain is run-in. Check the
chain tension regularly. A correctly tensioned chain
ensures good cutting performance and long life.
A
Adjusting the harness
CAUTION! Make sure that the drive shaft inside the shaft
engages with the cut-out in the cutting head.
Fitting the bar and chain
You should always use the harness with the machine to give
maximum control over the machine and reduce the risk of
fatigue in your arms and back.
Put on the harness.
Unscrew the bar nut and remove the protective cover.
Hook the machine onto the harness support hook.
Fit the bar over the bar bolt. Place the bar in its rearmost
position. Place the chain over the drive sprocket and in the
groove on the bar. Begin on the top side of the bar.
Adjust the length of the harness so that the support hook
is roughly level with your right hip.
Make sure that the edges of the cutting links are facing
forward on the top edge of the bar.
Fit the cover and locate the chain adjuster pin (A) in the hole
in the bar. Check that the drive links of the chain fit correctly
on the drive sprocket (B) and that the chain is in the groove in
the bar (C). Tighten the bar nut finger-tight.
C
Filling with oil
B
A
Open the cap on top of the bar head
Tension the chain by turning the chain tensioning screw
clockwise using the combination spanner. The chain should
be tensioned until it does not sag from the underside of the
bar.
Fill with Husqvarna saw chain oil.
Refit the cap.
16
English
Product Specification
CategoriesChainsaw Manuals, Husqvarna Chainsaw Manuals
Tags, ,
Model Year2003
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 32 pages
Document TypeOperator's Manual
LanguageEnglish
Product BrandHusqvarna, Chainsaw
Document File TypePDF
Publisherhusqvarna.com
Wikipedia's PageHusqvarna
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website