Husqvarna 323P4 325P5 X-Series Chainsaw Owners Manual

SAFETY INSTRUCTIONS
File all the teeth to the same length. When the length of
Place the file over the part of the lip that protrudes through
the cutting teeth is reduced to 4 mm (0.16") the chain is
worn out and should be replaced.
the gauge and file off the excess.The clearance is correct
when you no longer feel any resistance as you draw the
file over the gauge.
Tensioning the chain
General advice on setting raker clearance
When you sharpen the cutting teeth you reduce the raker
clearance (=cutting depth). To maintain optimal cutting
performance you must file back the raker lip to the
recommended height.
WARNING! A slack chain may jump off and
cause serious or even fatal injury.
!
The more you use a chain the longer it becomes. It is
therefore important to adjust the chain regularly to take up
the slack.
Check the chain tension every time you refuel. NOTE! A
new chain has a running-in period during which you
should check the tension more frequently.
On a low-kickback cutting link the front edge of the raker
lip is rounded. It is very important that you maintain this
radius or bevel when you adjust the raker clearance.
Tension the chain as tightly as possible, but not so tight
that you cannot pull it round freely by hand.
We recommend that you use our raker gauge to achieve
the correct clearance and bevel on the raker lip.
-
Undo the bar nut.
WARNING! The risk of kickback is increased
if the raker clearance is too large!
!
Setting the raker clearance
-
Tension the chain by turning the chain tensioning
screw clockwise using the combination spanner. The
chain should be tensioned until it does not sag from
the underside of the bar.
Before setting the raker clearance the cutting teeth should
be newly sharpened.
We recommend that you adjust the raker clearance every
third time you sharpen the chain. NOTE! This
recommendation assumes that the length of the cutting
teeth is not reduced excessively.
To adjust the raker clearance you will need a flat file and a
raker gauge.
Place the gauge over the raker lip.
English – 9
Product Specification
CategoriesChainsaw Manuals, Husqvarna Chainsaw Manuals
Tags, ,
Model Year2003
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 32 pages
Document TypeOperator's Manual
LanguageEnglish
Product BrandHusqvarna, Chainsaw
Document File TypePDF
Publisherhusqvarna.com
Wikipedia's PageHusqvarna
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website